Bouguer anomaly

In geodesy and geophysics, the Bouguer anomaly (named after Pierre Bouguer) is a gravity anomaly, corrected for the height at which it is measured and the attraction of terrain.[1] The height correction alone gives a free-air gravity anomaly.

Bouguer anomaly map of the state of New Jersey (USGS)

Definition

The Bouguer anomaly defined as:

Here,

  • is the free-air gravity anomaly.
  • is the Bouguer correction which allows for the gravitational attraction of rocks between the measurement point and sea level;
  • is a terrain correction which allows for deviations of the surface from an infinite horizontal plane

The free-air anomaly , in its turn, is related to the observed gravity as follows:

where:

  • is the correction for latitude (because the Earth is not a perfect sphere; see normal gravity);
  • is the free-air correction.

Reduction

A Bouguer reduction is called simple (or incomplete) if the terrain is approximated by an infinite flat plate called the Bouguer plate. A refined (or complete) Bouguer reduction removes the effects of terrain more precisely. The difference between the two is called the (residual) terrain effect (or (residual) terrain correction) and is due to the differential gravitational effect of the unevenness of the terrain; it is always negative.[2]

Simple reduction

The gravitational acceleration outside a Bouguer plate is perpendicular to the plate and towards it, with magnitude 2πG times the mass per unit area, where is the gravitational constant. It is independent of the distance to the plate (as can be proven most simply with Gauss's law for gravity, but can also be proven directly with Newton's law of gravity). The value of is 6.67×10−11 N m2 kg−2, so is 4.191×10−10 N m2 kg−2 times the mass per unit area. Using 1 Gal = 0.01 m s−2 (1 cm s−2) we get 4.191×10−5 mGal m2 kg−1 times the mass per unit area. For mean rock density (2.67 g cm−3) this gives 0.1119 mGal m−1.

The Bouguer reduction for a Bouguer plate of thickness is

where is the density of the material and is the constant of gravitation.[2] On Earth the effect on gravity of elevation is 0.3086 mGal m−1 decrease when going up, minus the gravity of the Bouguer plate, giving the Bouguer gradient of 0.1967 mGal m−1.

More generally, for a mass distribution with the density depending on one Cartesian coordinate z only, gravity for any z is 2πG times the difference in mass per unit area on either side of this z value. A combination of two parallel infinite if equal mass per unit area plates does not produce any gravity between them.

See also

Notes

  1. "Introduction to Potential Fields: Gravity" (PDF). U.S. Geological Survey Fact Sheets. FS–239–95. 1997. Retrieved 30 May 2019.
  2. Hofmann-Wellenhof & Moritz 2006, Section 3.4

References

  • Lowrie, William (2004). Fundamentals of Geophysics. Cambridge University Press. ISBN 0-521-46164-2.
  • Hofmann-Wellenhof, Bernard; Moritz, Helmut (2006). Physical Geodesy (2nd. ed.). Springer. ISBN 978-3-211-33544-4.
This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.