Bowling (cricket)

Pakistani Shoaib Akhtar holds the world record for delivering the fastest ball (161.3 km/h (100.2 mph)).[10]

In the early days of cricket, underarm bowling was the only method employed. Many theories exist about the origins of cricket. One suggests that the game began among shepherds hitting a stone or a ball of wool with their crooks and, at the same time, defending the wicket gate into the sheep-fold (from Anglo Saxon 'cricce', a crooked staff). A second theory suggests the name came from a low stool known as a 'cricket' in England, which from the side looked like the long, low wicket used in the early days of the game (originally from the Flemish 'krickstoel', a low stool on which parishioners knelt in church). There is also a reference to 'criquet' in North-East France in 1478 and evidence that the game evolved in South-East England in the Middle Ages.

In 1706 William Goldwyn published the first description of the game. He wrote that two teams were first seen carrying their curving bats to the venue, choosing a pitch and arguing over the rules to be played. They pitched two sets of wickets, each with a "milk-white" bail perched on two stumps; toss a coin for first knock, the umpire called "play" and the "leathern orb" was bowled. They had four-ball overs, the umpires leant on their staves (which the batters had to touch to complete a run), and the scorers sat on a mound making notches.

The first written "Laws of Cricket" were drawn up in 1744. They stated, "the principals shall choose from amongst the gentlemen present two umpires who shall absolutely decide all disputes. The stumps must be 22 inches high and the bail across them six inches. The ball must be between 5 & 6 ounces, and the two sets of stumps 22 yards apart". There were no limits on the shape or size of the bat. It appears that 40 notches was viewed as a very big score, probably due to the bowlers bowling quickly at shins unprotected by pads. The world's first cricket club was formed in Hambledon in the 1760s and the Marylebone Cricket Club (MCC) was founded in 1787.

During the 1760s and 1770s it became common to pitch the ball through the air, rather than roll it along the ground. This innovation gave bowlers the weapons of length, deception through the air, plus increased pace. It also opened new possibilities for spin and swerve. In response, batters had to master timing and shot selection. One immediate consequence was the replacement of the curving bat with the straight one. All of this raised the premium on skill and lessened the influence of rough ground and brute force. It was in the 1770s that the modern game began to take shape. The weight of the ball was limited to between five and a half and five and three-quarter ounces, and the width of the bat to four inches. The latter ruling followed an innings by a batter called Thomas "Daddy" White, who appeared with a bat the width of the wicket. In 1774, the first leg before law was published. Also around this time, a third stump became commonplace. By 1780, the duration of a first-class cricket match was generally three days, and this year also saw the creation of the first six-seam cricket ball. In 1788, the MCC published its first revision of the laws, which prohibited charging down an opponent and also provided for mowing and covering the wicket to standardise conditions. The desire for standardisation reflected the massive increase in the popularity of cricket during the 18th century. Between 1730 and 1740, 150 cricket matches were recorded in the papers of the time. Between 1750 and 1760, this figure rose to 230, and between 1770 and 1790 over 500.

The 19th century saw a series of significant changes. Wide deliveries were outlawed in 1811. The circumference of the ball was specified for the first time in 1838 (its weight had been dictated 60 years earlier). Pads, made of cork, became available for the first time in 1841, and these were further developed following the invention of vulcanised rubber, which was also used to introduce protective gloves in 1848. In the 1870s, boundaries were introduced – previously, all hits had to be run; if the ball went into the crowd, the spectators would clear a way for the fieldsman to fetch it. The biggest change, however, was in how the ball was delivered by the bowler.

At the start of the century, all bowlers were still delivering the ball under-arm. However, so the story goes, John Willes became the first bowler to use a "round-arm" technique after practising with his sister Christina, who had used the technique, as she was unable to bowl underarm due to her wide dress impeding her delivery of the ball.[11]

The round-arm action came to be employed widely in matches but was quickly determined to be illegal and banned by the MCC, who stated that "the ball must be delivered underhand, not thrown or jerked, with the hand underneath the elbow at the time of delivering the ball".[12] When it was accepted the rules stated that the arm could not be raised above the shoulder. It was quickly found, however, that a raised arm imparted more accuracy and generated more bounce than the roundarm method. Again, the governing body banned the method. It was not until the method was finally accepted by the MCC in 1835[13] that it grew rapidly in popularity amongst all players. Underarm bowling hitherto had almost disappeared from the game.

The typical bowling action of a fast bowler.

Australian fast bowler Brett Lee in action in 2005.

Bowling the ball is distinguished from simply throwing the ball by a strictly specified biomechanical definition.

Originally, this definition said that the elbow joint must not straighten out during the bowling action. Bowlers generally hold their elbows fully extended and rotate the arm vertically about the shoulder joint to impart velocity to the ball, releasing it near the top of the arc. Flexion at the elbow is not allowed, but any extension of the elbow was deemed to be a throw and would be liable to be called a no-ball. This was thought to be possible only if the bowler's elbow was originally held in a slightly flexed position.[16][17][18]

In 2005, this definition was deemed to be physically impossible by a scientific investigative commission. Biomechanical studies that showed that almost all bowlers extend their elbows somewhat throughout the bowling action, because the stress of swinging the arm around hyperextends the elbow joint. A guideline was introduced to allow extensions or hyperextensions of angles up to 15 degrees before deeming the ball illegally thrown.[16][18]

Bowling actions are typically divided into side on and front on actions. In the side on action, the back foot lands parallel to the bowling crease and the bowler aims at the wicket by looking over his front shoulder. In the front on action, the back foot lands pointing down the pitch and the bowler aims at the wicket by looking inside the line of his front arm. Many bowlers operate with a mid-way action with the back foot landing at roughly 45 degrees and the upper body aligned somewhere between side on and front on. This differs from a mixed action, which mixes distinct elements of both side on and front on actions, and is generally discouraged amongst young bowlers as it can lead to problems in later life due to the twisting of the back inherent in the action.

Philadelphian cricketer Bart King bowling

In a game of cricket, the ultimate priority of the fielding side is to restrict the total number of runs scored by the batting side, and the actions of the bowlers will be fundamental to achieving this objective. The primary means of achieving this is by dismissing the batting side by getting all ten of the opposition wickets as quickly as possible. A secondary objective will be to keep the batting side's run rate as low as possible. In fact, in most forms of cricket, the twin aims of the fielding side are targeted concurrently, as the achievement of one aim tends to have a positive effect upon the other. Taking regular opposition wickets will remove the better batsmen from the crease, typically leading to a slowing of the scoring rate. Conversely, slowing the scoring rate can put additional pressure on the batsmen and force them into taking extra risks, which will often lead to wickets.

Depending upon the format of the match, these two strategies will be given different weights. In an unlimited, timed or declaration match, the main aim of the bowling attack will be to take wickets, so attacking bowling and fielding strategies will be used. In a limited overs match, this aim will also be supplemented by the secondary need to prevent the batting side from scoring quickly, so more defensive strategies will be used. In general, the shorter the number of overs per side, the more priority will be given to this secondary target of maintaining a low run-rate. It is also highly probable that the need for attacking or defensive strategies can switch frequently as a cricket match progresses. It is the sign of a good cricket captain to be able to tell which strategy is most appropriate in any set of circumstances and the best way of implementing it.

Jim Allenby in midflight, illustrating the position of the body during a delivery at the end of a run up, prior to bowling the ball.

The simultaneous twin objectives of bowling are to take wickets and prevent run scoring opportunities. Both objectives are achieved through the underlying aim of bowling the ball in such a way that the batsman is unable to connect with the ball in the middle of the bat and control its movement after contact. There are three distinct means of achieving this aim: by bowling the ball on a good line and length, by bowling with sufficient pace that the batsman struggles to react to the delivery, or by bowling the ball in such a way that it has lateral movement as it approaches the batsman, either in the air or off the ground. A good bowler may be able to combine two of these skills, a truly great bowler may be able to combine all three.

In limited overs cricket, there is a limitation on the number of overs each bowler can bowl. This number depends on the match length, and is usually 20% of the total overs in the innings. For example, the usual limit for twenty-over cricket is four overs per bowler, for forty-over cricket eight per bowler and for fifty-over cricket ten per bowler. There is, however, no limit on the number of overs each bowler may bowl in first-class cricket matches, except that no two overs can be bowled consecutively thus restricting any one bowler from a maximum of 50% (plus 1 over) of each innings total. The rule also applies in terms of breaks within a Test innings (Drinks, Lunch and Tea breaks, end of day and beginning of next day). The rule can only be broken if one finishes the end of the previous match starts the next match.

Wikimedia Commons has media related to Bowling (cricket).

• Glossary of cricket terms
• Throwing
• Bowling machine
• Fielding
• Batting
• Over
• Pitch – throwing a baseball

• https://www.britannica.com/sports/bowling-cricket