Denis-Perron dam

Denis-Perron dam (French: Barrage Denis-Perron) is a rockfill embankment dam spanning the Sainte-Marguerite River, a tributary of the lower Saint Lawrence River, in eastern Quebec, Canada. Standing 171 metres (561 ft) high and 378 metres (1,240 ft) long,[2] the dam is the primary component of Hydro-Québec's Sainte-Marguerite 3 hydroelectric project.[1] The dam is the second highest in Quebec and the hydraulic head afforded to its power plant is also the largest in the province.

Denis-Perron dam
Denis-Perron dam is located in Quebec
Denis-Perron dam
Location of Denis-Perron dam in Quebec
CountryCanada
LocationSept-Rivières Regional County Municipality, Québec
Coordinates50°47′25″N 66°47′31″W
Construction began1994
Opening date2002
Construction costCA$ 2.4 billion
Owner(s)Hydro-Québec
Dam and spillways
Height171 m (561 ft)[1]
Length378 m (1,240 ft)[2]
Width (crest)10 m (33 ft)[2]
Width (base)500 m (1,600 ft)[2]
Dam volume6,325,000 m3 (8,273,000 cu yd)[2]
Reservoir
CreatesSainte-Marguerite 3 Reservoir
Total capacity12.5 km3 (10,100,000 acre⋅ft)[3]
Active capacity3.3 km3 (2,700,000 acre⋅ft)[3]
Catchment area9,000 km2 (3,500 sq mi)
Surface area253 km2 (63,000 acres)[1]
Sainte-Marguerite 3 Generating Station
Coordinates50°42′52.93″N 66°46′54.94″W
Commission date2003
Hydraulic head330 m (1,080 ft)[1]
Turbines2 x 441 MW Francis-type
Installed capacity882 MW[1]

Construction on the dam began in 1994 after seven years of studies and planning. Before construction began on the dam proper, a 19-metre (62 ft) high, 160-metre (520 ft) long cofferdam was raised to divert the river through a tunnel west of the dam site.[3] An average of 500 workers and a maximum of 1,200, most of whom lived in a construction camp that opened in January 1995, were employed at the dam site during construction. After the cutting of some 233 million board feet of lumber from the future reservoir site, the dam began to impound water in 1998 and finally reached capacity in 2001.[4] The dam and reservoir lie in a very remote region, and an 86-kilometre (53 mi) long access road had to be built to facilitate transportation to the construction site. No area residents were displaced as a result of the remote location,[1] but a large portion of the territory of the indigenous Innu people was flooded. In 1994, Hydro-Québec paid the local Innu CA$20.9 million as compensation.[5]

Full project completion was reached in 2002 at a cost of CA$2.4 billion, making it one of the most significant 21st century hydroelectric developments in North America.[6] After the dam was finished, temporary facilities used during construction were dismantled to ease impact on the local environment. The main workers' camp was actually demolished in 2001, a year before the project's final completion. These areas were replanted with some six hundred thousand trees.[3] Hydroelectricity generation began in 2003.[4] As of 2003, the dam was projected to generate about 2.73 TWh of electricity per year, or an average output of just over 310 megawatts (MW).[3]

The dam impounds a 140 km (87 mi) long, 253 km2 (63,000-acre) reservoir with a capacity of about 12.5 km3 (10,100,000 acre⋅ft). Excess water is released through a set of outlet works at the base of the dam, with a capacity of 1,440 m3/s (51,000 cu ft/s), and an emergency spillway about 1 km (0.62 mi) northwest of the dam. The spillway's three gates have a total capacity of 1,875 m3/s (66,200 cu ft/s), and its outflow rejoins the river about 1 km (0.62 mi) below the base of the dam.[3] Water is fed from the reservoir through an 8.3 km (5.2 mi) long penstock to the Sainte-Marguerite 3 generating plant, which is located underground and can produce up to 882 MW from two turbines.[1] Hydro-Québec is in the process of adding a third unit, bringing the total generating capacity to 1,322 MW, scheduled for completion in 2014.[7]

See also

References

  1. "Case Study 13-01: Improvement of Infrastructure – Sainte-Marguerite-3, Canada" (PDF). Hydropower Good Practices: Environmental Mitigation Measures and Benefits. International Energy Agency Implementing Agreement for Hydropower Technologies and Programmes. Archived from the original (PDF) on 2012-03-20. Retrieved 2012-05-08.
  2. "Denis-Perron Dam (Barrage Denis-Perron)". Structurae. Retrieved 2012-05-08.
  3. "L'aménagement hydroélectrique de la Sainte-Marguerite-3: En accord avec le milieu" (PDF) (in French). Hydro-Québec. Archived from the original (PDF) on 2003-03-28. Retrieved 2012-05-08.
  4. "Construction of the Sainte-Marguerite-3 Hydroelectric Development: Environmental Highlights" (PDF). Hydro Québec. 2002. Archived from the original (PDF) on 2008-12-09. Retrieved 2012-05-08.
  5. "Vulnerable social groups: Sainte Marguerite, Canada" (PDF). Sustainable Hydropower. Retrieved 2012-05-08.
  6. Lamontagne, Maurice; Hammamji, Yousef; Tournier, Jean-Pierre; Woodgold, Catherine (2006). "Reservoir-induced earthquakes at Sainte-Marguerite-3, Quebec, Canada". Canadian Journal of Earth Sciences. 43 (2): 135–146. Bibcode:2006CaJES..43..135L. doi:10.1139/e05-108.
  7. "Developing Québec's Hydropower Potential". Québec Hydropower: Energy For The Future. Hydro-Québec. October 2005. Retrieved 2012-05-08.
This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.