Flux limiter

The main idea behind the construction of flux limiter schemes is to limit the spatial derivatives to realistic values – for scientific and engineering problems this usually means physically realisable and meaningful values. They are used in high resolution schemes for solving problems described by PDEs and only come into operation when sharp wave fronts are present. For smoothly changing waves, the flux limiters do not operate and the spatial derivatives can be represented by higher order approximations without introducing spurious oscillations. Consider the 1D semi-discrete scheme below,

${\displaystyle {\frac {du_{i}}{dt}}+{\frac {1}{\Delta x_{i}}}\left[F\left(u_{i+{1}/{2}}\right)-F\left(u_{i-{1}/{2}}\right)\right]=0,}$

where, ${\displaystyle F\left(u_{i+{1}/{2}}\right)}$ and ${\displaystyle F\left(u_{i-1/2}\right)}$ represent edge fluxes for the i-th cell. If these edge fluxes can be represented by low and high resolution schemes, then a flux limiter can switch between these schemes depending upon the gradients close to the particular cell, as follows,

$${\displaystyle F\left(u_{i+1/2}\right)=f_{i+1/2}^{\text{low}}-\phi \left(r_{i}\right)\left(f_{i+1/2}^{\text{low}}-f_{i+1/2}^{\text{high}}\right),}$$

$${\displaystyle F\left(u_{i-1/2}\right)=f_{i-1/2}^{\text{low}}-\phi \left(r_{i-1}\right)\left(f_{i-1/2}^{\text{low}}-f_{i-1/2}^{\text{high}}\right),}$$

where

• ${\displaystyle f^{\text{low}}}$ is the low resolution flux,
• ${\displaystyle f^{\text{high}}}$ is the high resolution flux,
• ${\displaystyle \phi \ (r)}$ is the flux limiter function, and
• ${\displaystyle r}$ represents the ratio of successive gradients on the solution mesh, i.e.,
  $${\displaystyle r_{i}={\frac {u_{i}-u_{i-1}}{u_{i+1}-u_{i}}}.}$$

  

The limiter function is constrained to be greater than or equal to zero, i.e., ${\displaystyle \phi \ (r)\geq 0}$. Therefore, when the limiter is equal to zero (sharp gradient, opposite slopes or zero gradient), the flux is represented by a low resolution scheme. Similarly, when the limiter is equal to 1 (smooth solution), it is represented by a high resolution scheme. The various limiters have differing switching characteristics and are selected according to the particular problem and solution scheme. No particular limiter has been found to work well for all problems, and a particular choice is usually made on a trial and error basis.

The following are common forms of flux/slope limiter function, ${\displaystyle \phi (r)}$:

• CHARM [not 2nd order TVD] [1]
  $${\displaystyle \phi _{cm}(r)={\begin{cases}{\frac {r\left(3r+1\right)}{\left(r+1\right)^{2}}},&r>0,&\lim _{r\to \infty }\phi _{cm}(r)=3\\0\quad \quad \,,&r\leq 0\end{cases}}}$$

  
• HCUS [not 2nd order TVD] [2]
  $${\displaystyle \phi _{hc}(r)={\frac {1.5\left(r+\left|r\right|\right)}{\left(r+2\right)}};\quad \lim _{r\to \infty }\phi _{hc}(r)=3.}$$

  
• HQUICK [not 2nd order TVD] [2]
  $${\displaystyle \phi _{hq}(r)={\frac {2\left(r+\left|r\right|\right)}{\left(r+3\right)}};\quad \lim _{r\to \infty }\phi _{hq}(r)=4.}$$

  
• Koren[3] – third-order accurate for sufficiently smooth data[4]
  $${\displaystyle \phi _{kn}(r)=\max \left[0,\min \left(2r,\min \left({\dfrac {(1+2r)}{3}},2\right)\right)\right];\quad \lim _{r\to \infty }\phi _{kn}(r)=2.}$$

  
• minmod – symmetric [5]
  $${\displaystyle \phi _{mm}(r)=\max \left[0,\min \left(1,r\right)\right];\quad \lim _{r\to \infty }\phi _{mm}(r)=1.}$$

  
• monotonized central (MC) – symmetric [6]
  $${\displaystyle \phi _{mc}(r)=\max \left[0,\min \left(2r,0.5(1+r),2\right)\right];\quad \lim _{r\to \infty }\phi _{mc}(r)=2.}$$

  
• Osher [7]
  $${\displaystyle \phi _{os}(r)=\max \left[0,\min \left(r,\beta \right)\right],\quad \left(1\leq \beta \leq 2\right);\quad \lim _{r\to \infty }\phi _{os}(r)=\beta .}$$

  
• ospre – symmetric [2]
  $${\displaystyle \phi _{op}(r)={\frac {1.5\left(r^{2}+r\right)}{\left(r^{2}+r+1\right)}};\quad \lim _{r\to \infty }\phi _{op}(r)=1.5\,.}$$

  
• smart [not 2nd order TVD] [8]
  $${\displaystyle \phi _{sm}(r)=\max \left[0,\min \left(2r,\left(0.25+0.75r\right),4\right)\right];\quad \lim _{r\to \infty }\phi _{sm}(r)=4.}$$

  
• superbee – symmetric [5]
  $${\displaystyle \phi _{sb}(r)=\max \left[0,\min \left(2r,1\right),\min \left(r,2\right)\right];\quad \lim _{r\to \infty }\phi _{sb}(r)=2.}$$

  
• Sweby – symmetric [9]
  $${\displaystyle \phi _{sw}(r)=\max \left[0,\min \left(\beta r,1\right),\min \left(r,\beta \right)\right],\quad \left(1\leq \beta \leq 2\right);\quad \lim _{r\to \infty }\phi _{sw}(r)=\beta .}$$

  
• UMIST – symmetric [10]
  $${\displaystyle \phi _{um}(r)=\max \left[0,\min \left(2r,\left(0.25+0.75r\right),\left(0.75+0.25r\right),2\right)\right];\quad \lim _{r\to \infty }\phi _{um}(r)=2.}$$

  
• van Albada 1 – symmetric [11]
  $${\displaystyle \phi _{va1}(r)={\frac {r^{2}+r}{r^{2}+1}};\quad \lim _{r\to \infty }\phi _{va1}(r)=1.}$$

  
• van Albada 2 – alternative form [not 2nd order TVD] used on high spatial order schemes [12]
  $${\displaystyle \phi _{va2}(r)={\frac {2r}{r^{2}+1}};\quad \lim _{r\to \infty }\phi _{va2}(r)=0.}$$

  
• van Leer – symmetric [13]
  $${\displaystyle \phi _{vl}(r)={\frac {r+\left|r\right|}{1+\left|r\right|}};\quad \lim _{r\to \infty }\phi _{vl}(r)=2.}$$

  
• All the above limiters indicated as being symmetric, exhibit the following symmetry property,
  $${\displaystyle {\frac {\phi \left(r\right)}{r}}=\phi \left({\frac {1}{r}}\right).}$$

  

This is a desirable property as it ensures that the limiting actions for forward and backward gradients operate in the same way.

Admissible limiter region for second-order TVD schemes.

Unless indicated to the contrary, the above limiter functions are second order TVD. This means that they are designed such that they pass through a certain region of the solution, known as the TVD region, in order to guarantee stability of the scheme. Second-order, TVD limiters satisfy at least the following criteria:

• ${\displaystyle r\leq \phi (r)\leq 2r,\left(0\leq r\leq 1\right)\ }$,
• ${\displaystyle 1\leq \phi (r)\leq r,\left(1\leq r\leq 2\right)\ }$,
• ${\displaystyle 1\leq \phi (r)\leq 2,\left(r>2\right)\ }$,
• ${\displaystyle \phi (1)=1\ }$,

The admissible limiter region for second-order TVD schemes is shown in the Sweby Diagram opposite,[9] and plots showing limiter functions overlaid onto the TVD region are shown below. In this image, plots for the Osher and Sweby limiters have been generated using ${\displaystyle \beta =1.5}$.

Limiter functions overlaid onto second-order TVD region.

Generalised minmod limiter

An additional limiter that has an interesting form is the van-Leer's one-parameter family of minmod limiters.[14][15][16] It is defined as follows

$${\displaystyle \phi _{mg}(u,\theta )=\max \left(0,\min \left(\theta r,{\frac {1+r}{2}},\theta \right)\right),\quad \theta \in \left[1,2\right].}$$

Note: ${\displaystyle \phi _{mg}}$ is most dissipative for ${\displaystyle \theta =1,}$ when it reduces to ${\displaystyle \phi _{mm},}$ and is least dissipative for ${\displaystyle \theta =2}$.

• Godunov's theorem
• High resolution scheme
• MUSCL scheme
• Sergei K. Godunov
• Total variation diminishing

• Hirsch, C. (1990), Numerical Computation of Internal and External Flows, Volume 2: Computational Methods for Inviscid and Viscous Flows, Wiley, ISBN 978-0-471-92452-4
• Leonard, B.P.; Leschziner, M.A.; McGuirk, J. (1978), "The QUICK algorithm: a uniformly 3rd-order finite-difference method for highly convective flows", Proc. 1st Conf. on Numerical Methods in Laminar & Turbulent Flow, Swansea, p. 807{{citation}}: CS1 maint: location missing publisher (link)

• Laney, Culbert B. (1998), Computational Gasdynamics, Cambridge University Press, ISBN 978-0-521-57069-5
• LeVeque, Randall (1990), Numerical Methods for Conservation Laws, ETH Lectures in Mathematics Series, Birkhauser-Verlag, ISBN 3-7643-2464-3
• LeVeque, Randall (2002), Finite Volume Methods for Hyperbolic Problems, Cambridge University Press, ISBN 0-521-00924-3
• Toro, E.F. (1999), Riemann Solvers and Numerical Methods for Fluid Dynamics (2nd ed.), Springer-Verlag, ISBN 3-540-65966-8
• Tannehill, John C.; Anderson, Dale Arden; Pletcher, Richard H. (1997), Computational Fluid Mechanics and Heat Transfer (2nd ed.), Taylor and Francis, ISBN 1-56032-046-X
• Wesseling, Pieter (2001), Principles of Computational Fluid Dynamics, Springer-Verlag, ISBN 3-540-67853-0