Thermal stress

When a material is rapidly heated or cooled, the surface and internal temperature will have a difference in temperature. Quick heating or cooling causes thermal expansion or contraction respectively, this localized movement of material causes thermal stresses. Imagine heating a cylinder, first the surface rises in temperature and the center remains the same initial temperature. After some time the center of the cylinder will reach the same temperature as the surface. During the heat up the surface is relatively hotter and will expand more than the center. An example of this is dental fillings can cause thermal stress in a person's mouth. Sometimes dentists use dental fillings with different thermal expansion coefficients than tooth enamel, the fillings will expand faster than the enamel and cause pain in a person's mouth.

Example of deformation induced by thermal stress on the rails

Material will expand or contract depending on the material's thermal expansion coefficient. As long as the material is free to move, the material can expand or contract freely without generating stresses. Once this material is attached to a rigid body at multiple locations, thermal stresses can be created in the geometrically constrained region. This stress is calculated by multiplying the change in temperature, material's thermal expansion coefficient and material's Young's modulus (see formula below). ${\displaystyle E}$ is Young's modulus, ${\displaystyle \alpha }$ is thermal expansion coefficient, ${\displaystyle T_{0}}$ is initial temperature and ${\displaystyle T_{f}}$ is the final temperature.[2][3]

${\displaystyle \sigma =E\alpha \left(T_{f}-T_{0}\right)=E\alpha \Delta {T}}$

When ${\displaystyle T_{f}}$ is greater than ${\displaystyle T_{0}}$, the constraints exert a compressive force on the material. The opposite happens while cooling; when ${\displaystyle T_{f}}$ is less than ${\displaystyle T_{0}}$, the stress will be tensile. A welding example involves heating and cooling of metal which is a combination of thermal expansion, contraction, and temperature gradients. After a full cycle of heating and cooling, the metal is left with residual stress around the weld.

This is a combination of a large temperature gradient due to low thermal conductivity, in addition to rapid change in temperature on brittle materials. The change in temperature causes stresses on the surface that are in tension, which encourages crack formation and propagation. Ceramics materials are usually susceptible to thermal shock.[2] An example is when glass is heated up to a high temperature and then quickly quenched in cold water. As the temperature of the glass falls rapidly, stresses are induced and causes fractures in the body of the glass which can be seen as cracks or even shattering in some cases.