Outbound Systems
Outbound Systems, Inc., was an American computer company based in Boulder, Colorado. Founded by Warren Conner in 1989,[1][2] the company offered Macintosh clone computer systems in various portable form factors between 1989 and 1991.[3][4] It left the Mac conversion business in 1992 to build windows-based desktop computers before going bankrupt in 1993.
Type | Private |
---|---|
Industry | Computers |
Founded | 1989Boulder, Colorado | in
Founder | Warren Conner |
Defunct | 1993 |
Fate | Bankruptcy |
Products |
|
Wallaby laptop
Developer | Outbound Systems, Inc. |
---|---|
Type | Laptop |
Release date | 1989 |
Introductory price | US$4,000 (equivalent to $9,443 in 2022) |
Discontinued | 1993 |
CPU | Motorola 68000, 15 MHz |
The company's first product, the Wallaby, was a Mac clone laptop. It is powered by a 15-MHz Motorola 68000 processor. Later versions increased the clock speed to 20 MHz.
The Wallaby laptop was introduced in 1989 and was significantly lighter, at just over 4 kg, and easier to carry than Apple's own Macintosh Portable released at around the same time. Due to Apple's refusal to license the Macintosh Toolbox in read-only memory (ROM), Wallaby users had to install a Mac ROM to make the computer work. The ROM was typically removed from an older Mac, a process that would render the donor Mac unusable except when docked with the laptop using a special cable. Even with this additional cost, a typical price of $4,000 USD compared favorably to that of the Mac Portable.
The Wallaby featured a built-in pointing device located below the keyboard, named the Trackbar (with earlier models referring to it under the trademark of Isopoint); it was a cylinder that scrolled up and down and slid left and right. It ran on standard camcorder batteries, rather than the expensive custom batteries commonly found in most portable computers around this time.
Outbound notebook
The Wallaby laptop was succeeded by the Outbound notebook in 1991.
The Notebook ran on the same style of lead-acid camcorder batteries as the earlier Laptop, and had a 9.7" passive-matrix monochrome LCD display. It used a 2.5" IDE hard drive, which was unusual for the time, as Apple didn't start using IDE drives in PowerBooks until the PowerBook 150 in 1994. The Notebook had an internal microphone and speaker, headphone jack, two serial ports, ADB port, and SCSI port. The Notebook's SCSI port was unique in that it supported the Outbound Outrigger full-page external monochrome monitor, which attached via the SCSI port.
The Notebook's CPU, RAM, Mac ROM, and optional 68882 FPU were mounted on a removable daughtercard. This permitted easy RAM installation and optional upgrades; the daughtercard could simply be swapped out for another one with a faster CPU, or an FPU inserted into the available socket. The daughtercard had four 30-pin SIMM sockets. Due to the Notebook's design, only 4MB of RAM could be addressed by the Mac system software, even in System 7; additional RAM would appear as a "Silicon Disk" which was an Outbound specific RAM disk.
Demise
Apple's introduction of the PowerBook in 1991 led to the demise of the Mac-compatible laptop aftermarket. Probably more significant than the increased competition, was the fact that Outbound was using ROMs under a licensing agreement with Apple. Apple refused to license the use of subsequent proprietary ROMs to Outbound and so the company's ability to manufacture laptops ended when the 68000 processors required by the ROMs became difficult to obtain. Although Outbound attempted a turnaround by pivoting toward building windows-based desktop computers in 1992,[5][6] mounting debts of nearly $5 million by 1993 led the company to miss payrolls and prompted the company to close its doors entirely in February that year.[7] For a short time after Outbound went out of business, a small group of former employees set up a company, PerFit, to handle service and warranty issues. PerFit ceased operations in 1994.
Gallery
- The removable hard drive, showing the drive bay and plastic shield. The shield protects the components on the bottom of the drive, as well as having a pull-tab to aid removal of the drive. The cover slides down and out.
- The components on the bottom of the drive.
- The rear connectors of the notebook.
- The right-hand side of the notebook case.
- The TrackBar and two buttons, one on either side of the bar. The TrackBar rolls towards/away from the user, as well as moving left to right.
- The ROM SIMM removed, showing additional memory modules. The CPU daughtercard slides out of the case to provide access to the RAM slots.
- The rear has a memory access panel cover which, once removed, allows access to the CPU daughtercard.
References
- "Electronic Business, Volume 16, Issues 9-16". Cahners Publishing Company. 1990.
founded in 1989
- "Design's Secret Weapon". Metropolitan Home. 23 (3): 102–105. March 1991 – via Google Books.
- "Outbound Laptop and Notebook". LowEndMac.com. July 3, 2016.
It was announced in August 1989
- Flynn, Laurie and Krohn, Nico (January 21, 1991). "Outbound, Dynamac Show Laptops". Macintosh News.
Outbound Adds Classic Support
{{cite web}}
: CS1 maint: multiple names: authors list (link) - Lee, Yvonne (November 9, 1992). "Outbound offers network-ready PC". InfoWorld News.
Outbound Systems has used its experience making Macintosh-compatible notebooks to create an Intel-based miniature computer
- "News - industry troubles". The computists' weekly. December 16, 1992.
Outbound Systems Inc. (Boulder) is ceasing production.
- Staff writer (February 15, 1993). "Outbound Systems Goes Out of Business". Information Technology Digest. The Division. 2 (3): 15 – via Google Books.
External links
- Outbound Laptop on AppleFritter – review with pictures
- Outbound Laptop on LowEndMac - specifications
- Outbound Notebook on Obsolete Computer Museum - review and pictures of the Notebook model
- Article describing the Outbound Laptop (in French; via Wayback Machine)
- What's Outbound got that Apple doesn't? (via Wayback Machine)