Semi-trailer aerodynamic device

Semi-trailer aerodynamic devices are devices affixed to semi-trailers, for the purpose of reducing aerodynamic drag caused by air turbulence. The two major types of device in use are trailer skirts (or side skirts), affixed to the underside of trailers, and trailer tails (or boat tails, or rear fairings), affixed to the rear. Several such devices have been recognized by the U.S. Environmental Protection Agency's SmartWay Transport Partnership, making them eligible for funding under the Diesel Emissions Reduction Act.[1]

Trailer skirts
Detail of trailer skirt
Walmart truck with trailer skirts installed
A semi-trailer truck with trailer skirts installed

Construction

Trailer skirts comprise a pair of panels affixed to the lower side edges of a trailer, running most of the length of the trailer and filling the gap between the forward and rear axles. Trailer skirts are typically constructed of aluminum, plastic, or fiberglass, with plastic the most resistant to damage from side or bottom impacts.[2] Skirts may have a modular design, allowing installation on a variety of trailer lengths.[3] Skirts may weigh between 70 and 160 kg (150 and 350 lb).[4] Installation typically requires three to five person-hours.[4]

Cost

As of 2009, a set of trailer skirts cost between C$1500 and C$3000 (US$1300 to $2700).[4] Standard trailer skirts have an estimated payback period of ten to eighteen months, while "advanced" skirts (those that improve fuel efficiency by over 7%) are estimated to pay for themselves in seven to fourteen months.[4]

Performance

A 2012 investigation by SAE International of nine trailer skirt designs found that three provided fuel savings greater than 5%, and four provided savings between 4% and 5%, compared with an unmodified trailer.[5] Skirts with reduced ground clearance offer greater fuel savings; in one instance, reducing ground clearance from 16 in (41 cm) to 8 in (20 cm) resulted in an improvement in fuel savings from 4% to 7%.[2] One 2008 Delft University of Technology study found fuel savings of up to 15% for the particular design studied.[6] Sean Graham, president of a major supplier of trailer skirts, estimates that in typical use, drivers see fuel savings of 5% to 6%.[2]

Trailers with skirts fitted have also demonstrated reduced tire spray, and drivers have reported improved stability in crosswinds.[4]

Adoption

As of 2018, over 60% of new trailers produced in Australia are equipped with skirts, whereas the figure is over 50% for the North American market.

A 2014 study by the North American Council for Freight Efficiency on adoption of fuel efficient technologies and practices found trailer skirts to be the most widely adopted technology of those studied, having been adopted by seven of the ten major shipping fleets in the study.[7]

Since the wide adoption of trailer skirts, incidents of them becoming detached and hurting other drivers on the road have increased. On October 18, 2018, in one particular case, a trailer skirt came off of an east bound tractor trailer and ended up in the west bound lanes where it hit a car and killed its driver while he was traveling through Knoxville, Tennessee.[8][9]

Trailer tails
Trailer tail at the rear of a semi-trailer in 2013

Trailer tails, boat tails, or rear fairings comprise a set of panels, usually collapsible, which fold out from the rear of the trailer, creating a tapered shape that reduces drag from the low-pressure wake created behind the trailer. Trailer tails alone have demonstrated a fuel savings of 1%–5%, and in concert with trailer skirts, 9% improvement has been demonstrated.[10]

TrailerTail is a registered trademark of STEMCO.[11][12]

SuperTruck project

At least one model of trailer tail, trade named TrailerTail, is part of Navistar's SuperTruck project,[13] which will use $37 million of US Department of Energy grants to build next generation trucks and tractor trailers.

See also

References
  1. "Verified Aerodynamic Technologies". SmartWay Technology: About the SmartWay Technology Program. Environmental Protection Agency. Retrieved September 17, 2014.
  2. "Trailer skirts: A proven fuel-saver". trucknews.com. Business Information Group. Retrieved September 17, 2014.
  3. "New Aerodynamic Trailer Skirt Technology Introduced". Trucking Info. March 26, 2013. Retrieved September 17, 2014.
  4. "Trailer side skirts". On the Road to a fuel-efficient truck: A Guide for Purchasing Aerodynamics for Heavy-Duty Tractors and Trailers. Natural Resources Canada. September 2009. Retrieved September 17, 2014.
  5. Wood, Richard (September 24, 2012). "EPA Smartway Verification of Trailer Undercarriage Advanced Aerodynamic Drag Reduction Technology". SAE International. Retrieved September 17, 2014.
  6. "Aerodynamic Truck Trailer Cuts Fuel And Emissions By Up To 15 Percent". Delft University of Technology. Science Daily. April 22, 2008. Retrieved September 17, 2014.{{cite web}}: CS1 maint: others (link)
  7. Dunn, Jill (September 8, 2014). "Study: Fuel efficiency efforts pay off for carriers". Commercial Carrier Journal – Fleet Management Magazine. Randall-Reilly. Retrieved September 17, 2014.
  8. "KPD names driver killed by flying metal piece from tractor-trailer". wbir.com.
  9. "Fleets Adopt Trailer Fuel-Efficiency Tech as Federal Rules Stall". Trucks.com. August 29, 2018.
  10. "SmartWay Verified List of Aerodynamic Devices". U.S. Environmental Protection Agency. Retrieved 29 June 2016.
  11. "TrailerTail® Fuel Savings Technology". stemco.com. Retrieved 2018-10-15.
  12. U.S. Trademark 77,152,970
  13. Navistar SuperTruck Archived July 17, 2011, at the Wayback Machine
This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.