Soil salinity

Salts are a natural component in soils and water. The ions responsible for salination are: Na⁺, K⁺, Ca²⁺, Mg²⁺ and Cl⁻.

Over long periods of time, as soil minerals weather and release salts, these salts are flushed or leached out of the soil by drainage water in areas with sufficient precipitation. In addition to mineral weathering, salts are also deposited via dust and precipitation. Salts may accumulate in dry regions, leading to naturally saline soils. This is the case, for example, in large parts of Australia.

Human practices can increase the salinity of soils by the addition of salts in irrigation water. Proper irrigation management can prevent salt accumulation by providing adequate drainage water to leach added salts from the soil. Disrupting drainage patterns that provide leaching can also result in salt accumulations. An example of this occurred in Egypt in 1970 when the Aswan High Dam was built. The change in the level of ground water before the construction had enabled soil erosion, which led to high concentration of salts in the water table. After the construction, the continuous high level of the water table led to the salination of arable land.

When the Na⁺ (sodium) predominates, soils can become sodic. The pH of sodic soils may be acidic, neutral or alkaline.

Sodic soils present particular challenges because they tend to have very poor structure which limits or prevents water infiltration and drainage. They tend to accumulate certain elements like boron and molybdenum in the root zone at levels that may be toxic for plants.[2] The most common compound used for reclamation of sodic soil is gypsum, and some plants that are tolerant to salt and ion toxicity may present strategies for improvement.[3]

The term "sodic soil" is sometimes used imprecisely in scholarship. It's been used interchangeably with the term alkali soil, which is used in two meanings: 1) a soil with a pH greater than 8.2, 2) a soil with an exchangeable sodium content in excess of 15% of exchange capacity. The term "alkali soil" is often, but not always, used for soils that meet both of these characteristics.[4]

Salinity in drylands can occur when the water table is between two and three metres from the surface of the soil. The salts from the groundwater are raised by capillary action to the surface of the soil. This occurs when groundwater is saline (which is true in many areas), and is favored by land use practices allowing more rainwater to enter the aquifer than it could accommodate. For example, the clearing of trees for agriculture is a major reason for dryland salinity in some areas, since deep rooting of trees has been replaced by shallow rooting of annual crops.

Rain or irrigation, in the absence of leaching, can bring salts to the surface by capillary action

Salinity from irrigation can occur over time wherever irrigation occurs, since almost all water (even natural rainfall) contains some dissolved salts.[5] When the plants use the water, the salts are left behind in the soil and eventually begin to accumulate. This water in excess of plant needs is called the leaching fraction. Salination from irrigation water is also greatly increased by poor drainage and use of saline water for irrigating agricultural crops.

Salinity in urban areas often results from the combination of irrigation and groundwater processes. Irrigation is also now common in cities (gardens and recreation areas).

The consequences of salinity are

• Detrimental effects on plant growth and yield
• Damage to infrastructure (roads, bricks, corrosion of pipes and cables)
• Reduction of water quality for users, sedimentation problems, increased leaching of metals,[6] especially copper, cadmium, manganese and zinc.
• Soil erosion ultimately, when crops are too strongly affected by the amounts of salts.
• More energy required to desalinate

Salinity is an important land degradation problem. Soil salinity can be reduced by leaching soluble salts out of soil with excess irrigation water. Soil salinity control involves watertable control and flushing in combination with tile drainage or another form of subsurface drainage.[7][8] A comprehensive treatment of soil salinity is available from the United Nations Food and Agriculture Organization.[9]

High levels of soil salinity can be tolerated if salt-tolerant plants are grown. Sensitive crops lose their vigor already in slightly saline soils, most crops are negatively affected by (moderately) saline soils, and only salinity-resistant crops thrive in severely saline soils. The University of Wyoming[10] and the Government of Alberta[11] report data on the salt tolerance of plants.

Field data in irrigated lands, under farmers' conditions, are scarce, especially in developing countries. However, some on-farm surveys have been made in Egypt,[12] India,[13] and Pakistan.[14] Some examples are shown in the following gallery, with crops arranged from sensitive to very tolerant.[15][16]

• Graphs of crop yield and soil salinity in farmers' fields ordered by increasing salt tolerance.
• 
  Fig. 1. Berseem (clover), cultivated in Egypt's Nile Delta, is a salt-sensitive crop and tolerates an ECe value up to 2.4 dS/m, whereafter yields start to decline.
• 
  Fig. 2. Wheat grown in Sampla, Haryana, India, is slightly sensitive, tolerating an ECe value of 4.9 dS/m.
• 
  Fig. 3. The field measurements in wheat fields in Gohana, Haryana, India, showed a higher tolerance level of ECe = 7.1 dS/m.
  (The Egyptian wheat, not shown here, exhibited a tolerance point of 7.8 dS/m).
• 
  Fig. 4. The cotton grown in the Nile Delta can be called salt-tolerant, with a critical ECe value of 8.0 dS/m. However, due to scarcity of data beyond 8 dS/m, the maximum tolerance level cannot be precisely determined and may actually be higher than that.
• 
  Fig. 5. Sorghum from Khairpur, Pakistan, is quite tolerant; it grows well up to ECe = 10.5 dS/m.
• 
  Fig. 6. Cotton from Khairpur, Pakistan, is very tolerant; it grows well up to ECe = 15.5 dS/m.

Calcium has been found to have a positive effect in combating salinity in soils. It has been shown to ameliorate the negative effects that salinity has such as reduced water usage of plants.[17]

From the FAO/UNESCO Soil Map of the World the following salinised areas can be derived.[18]

• Alkali soil – Soil type with pH > 8.5
• Arabidopsis thaliana responses to salinity
• Biosaline agriculture – Production of crops in salt-rich conditions
• Biosalinity – Use of salty water for irrigation
• Crop tolerance to seawater – Crop tolerance to seawater is the ability of an agricultural crop to withstand the high salinity induced by irrigation with seawater.Pages displaying wikidata descriptions as a fallback
• Desalination – Removal of salts from water
• Environmental impacts of deicing salt – Process of removing ice, snow, or frost from a surfacePages displaying short descriptions of redirect targets
• Halophyte – Salt-tolerant plant
• Halotolerance – Adaptation to high salinity
• Salinity in Australia
• Salt tolerance of crops
• Sodium in biology – Use of Sodium by organisms
• Water softening – Removing positive ions from hard water
• U.S. Salinity Laboratory – National Laboratory for research on salt-affected soil

• Article on water and salt balances in the soil
• Download leaching model for saline soils
• Salt of the Earth Documentary produced by Prairie Public Television