California State Route 262

State Route 262 (SR 262) is a state highway entirely within the Warm Springs District of Fremont, California. It runs along the 1.07-mile (1.72 km) segment of Mission Boulevard between I-880 to the west and I-680 to the east. The route is heavily trafficked, going through a commercial district and containing at least two stop lights.

State Route 262 marker

State Route 262

Mission Boulevard
SR 262 highlighted in red
Route information
Maintained by Caltrans
Length1.070 mi[1] (1.722 km)
Existed2000 (2000)–present
History1965–2000 (unsigned)
Major junctions
South end I-880 in Fremont
North end I-680 in Fremont
Location
CountryUnited States
StateCalifornia
CountiesAlameda
Highway system
SR 261 SR 263

Route description

Aerial photo of Route 262 from the east

SR 262 begins at its western interchange with Interstate 880 in Fremont. It travels 1-mile (1.6 km) east to its terminus and junction with Interstate 680 in Fremont. SR 262 was built solely to be a link between the two interstates and lies at the point that Interstates 880 and 680 are closest together in the East Bay. 2 miles (3.2 km) north of SR 262, I-680 abruptly turns to the Northeast and into the Sunol and Livermore Valley thus making SR 262 a vital link between those valleys and the Silicon Valley to the south.

Physically SR 262 begins as a 6 lane road that has been built to freeway standards for its first half mile and after intersecting Kato Road and Warren Avenue with separated grade intersections built in 2008 and 2015, respectively. The remaining half mile is a 4-6 lane city street with two traffic lights at Warm Springs Blvd and Mohave Drive before terminating at a cloverleaf interchange at I-680.

SR 262 is unsigned along its entire route and would be unnoticeable to the public if not for two guide signs placed in the early 2000s on south I-680 that designate the exit as "SR 262 to I-880 Mission Blvd". There is no other signage on I-880 that designates the road by its route number. Signage for the southbound I-680 toll express lane, opened in September 2010, indicates an exit at "262 - Mission Blvd." Locals are largely unaware of the route designation and refer to the road as Mission Blvd exclusively. Street signage of Route 262 appeared in 2018 at Warm Springs Boulevard. In 2021, signage for Route 262 was placed in the westbound (southbound) direction of Mission Boulevard between I-680 and Warm Springs Boulevard.

SR 262 is part of the National Highway System,[2] a network of highways that are considered essential to the country's economy, defense, and mobility by the Federal Highway Administration.[3]

History

Originally SR 262 was slated to run the route of present-day Oakland Road from San Jose to where present day Warm Springs Blvd and Mission Blvd intersect. This plan was scrapped when State Route 17 (later I-880) was constructed. SR 262 was subsequently routed along its present route.

One planning option was for SR 262 to be deleted from the state route list when State Route 237 to the south was completed between I-880 and I-680. However, there is no longer room between the developed areas to build 237 into a freeway there.

SR 262 is also a signed section of the Juan Bautista De Anza National Historic Trail.

Major intersections

Except where prefixed with a letter, postmiles were measured on the road as it was in 1964, based on the alignment that existed at the time, and do not necessarily reflect current mileage. R reflects a realignment in the route since then, M indicates a second realignment, L refers to an overlap due to a correction or change, and T indicates postmiles classified as temporary (for a full list of prefixes, see California postmile § Official postmile definitions).[1] Segments that remain unconstructed or have been relinquished to local control may be omitted. The entire route is in Fremont, Alameda County.

Postmile
[1][4][5]
ExitDestinationsNotes
R0.00 I-880 (Nimitz Freeway) Oakland, San JoseSouthbound exit and northbound entrance; south end of SR 262; former SR 17; I-880 north exit 12A, south exit 12
Gateway BoulevardClosed; former southbound exit and entrance
R0.391Kato RoadSouthbound exit and northbound entrance, opened in 2015
North end of freeway
R0.70Warm Springs Boulevard – Irvington District, Warm Springs District
R1.07 I-680 Sacramento, MilpitasInterchange; north end of SR 262; I-680 exit 12
R1.07Mission BoulevardContinuation beyond I-680; former SR 21 north
1.000 mi = 1.609 km; 1.000 km = 0.621 mi

See also

References

  1. California Department of Transportation. "State Truck Route List". Sacramento: California Department of Transportation. Archived from the original (XLS file) on June 30, 2015. Retrieved June 30, 2015.
  2. Federal Highway Administration (March 25, 2015). National Highway System: San Francisco–Oakland, CA (PDF) (Map). Scale not given. Washington, DC: Federal Highway Administration. Retrieved September 3, 2017.
  3. Natzke, Stefan; Neathery, Mike & Adderly, Kevin (June 20, 2012). "What is the National Highway System?". National Highway System. Washington, DC: Federal Highway Administration. Retrieved July 1, 2012.
  4. California Department of Transportation (July 2007). "Log of Bridges on State Highways". Sacramento: California Department of Transportation.
  5. California Department of Transportation, All Traffic Volumes on CSHS, 2005 and 2006
Template:Attached KML/California State Route 262
KML is from Wikidata
This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.