Shunting (rail)

The terms "shunter" and "switcher" are not only applied to locomotives but also to employees engaged on the ground with shunting/switching operations. The task of such personnel is particularly dangerous because not only is there the risk of being run over, but on some railway systems—particularly ones that use buffer-and-chain/screw coupling systems—the shunters have to get between the wagons/carriages in order to complete coupling and uncoupling. This was particularly so in the past. The Midland Railway company, for example, kept an ambulance wagon permanently stationed at Toton Yard to give treatment to injured shunters.

Of the 20,964 staff accidents in the UK that were investigated by the Railway Inspectorate between 1900 and 1939 (around 3% of all staff accidents), 6701 have been classified as involving shunting. Of those 6701 cases, 1033 were fatalities. All of the 20,964 Railway Inspectorate accident investigations have been transcribed and made freely available by the Railway Work, Life & Death project, along with around 28,000 other cases.[1]

Light dual-mode (electric and diesel) shunter SBB Tem 346 at work on the Swiss Federal Railways

The main tool of shunters working with hook-and-chain couplings was a shunting pole, which allowed the shunter to reach between wagons to fasten and unfasten couplings without having physically to go between the vehicles. This type of shunting pole was of an entirely different design than objects of the same name in North American practice (see below).[2]

A shunting pole preserved at the National Railroad Museum in Green Bay, Wisconsin, US

In some countries, a pole was sometimes used to move cars on adjacent tracks. In the United States this procedure was known as "pole switching" or "poling" for short. In the UK it was known as "propping." In these instances, the locomotive or another car was moved to be near the car that needed to be moved. The on-ground railwayman would then position a wooden pole, which was sometimes permanently attached to the locomotive, and engage it in the poling pocket of the car that needed to be moved. The engineer would then use the pole to push the car on the adjacent track.[3][4][5][6][7] Before poling pockets or poles were common on switching locomotives, some US railroads built specialized poling cars which could be coupled to locomotives that lacked poling pockets.[8][9] The practice was most prevalent in rail yard operations circa 1900.[10] Poling was the cause of some accidents and in later years was discouraged before the practice was abandoned.[11][12][13][14][15]