Three-detector problem and Newell's method

Assumption. In this special case, we use the Triangular Fundamental Diagram (TFD) with three parameters: free flow speed ${\displaystyle v_{f}}$, wave velocity -w and maximum density ${\displaystyle k_{j}}$ (see Figure 1). Additionally, we will consider a long study period where traffic past upstream detector (U) is unrestricted and traffic past downstream detector (D) is restricted so that waves from both boundaries point into the (t,x) solution space (see Figure 2).

The goal of three-detector problem is calculating the vehicle at a generic point (P) on the "world line" of detector M (See Figure 2). Upstream. Since the upstream state is uncongested, there must be a characteristic with slope ${\displaystyle v_{f}}$ that reaches P from the upstream detector. Such a wave must be emitted ${\displaystyle \tau _{1}=L_{U}/v_{f}}$ times unit earlier, at point P' on the figure. Since the vehicle number does not change along this characteristic, we see that the vehicle number at the M-detector calculated from conditions upstream is the same as that observed at the upstream detector ${\displaystyle \tau _{1}}$ time units earlier. Since ${\displaystyle \tau _{1}}$ is independent of the traffic state (it is a constant), this result is equivalent to shifting the smoothed N-curve of the upstream detector (curve U of Figure 3) to the right by an amount ${\displaystyle \tau _{1}}$.

Downstream. Likewise, since the state over the downstream detector is queued, there will be a wave reaching P from a location ${\displaystyle P_{2}}$ with wave velocity ${\displaystyle -w<0}$. The change in vehicular label along this characteristic can be obtained from the moving observer construction of Figure 4, for an observer moving with the wave. In our particular case, the slanted line corresponding to the observer is parallel to the congested part of TFD. This means that the observer flow is independent of the traffic state and takes on the value: ${\displaystyle k_{j}(-w)}$. Therefore, in the time that it takes for the wave to reach the middle location, ${\displaystyle \tau _{2}=L_{D}/(-w)}$, the change in count is ${\displaystyle \delta =k_{j}(-w)\tau _{2}=k_{j}L_{D}}$; i.e., the change in count equals the number of vehicles that fit between M and D at jam density. This result is equivalent to shifting the D-curve to the right ${\displaystyle \tau _{2}}$ units and up ${\displaystyle \delta }$ units.

Actual count at M. In view of the Newell-Luke Minimum Principle, we see that the actual count at M should be the lower envelope of the U'- and D'-curves. This is the dark curves, M(t). The intersections of the U'- and D'- curves denote the shock's passages over the detector; i.e., the times when transitions between queued and unqueued states take place as the queue advances and recedes over the middle detector. The area between the U'- and M-curves is the delay experienced upstream of location M, trip times are the horizontal separation between curves U(t), M(t) and D(t), accumulation is given by vertical separations, etc.

Mathematical expression. In terms of the function N(t,x) and the detector location (${\displaystyle x_{u}}$, ${\displaystyle x_{m}}$, ${\displaystyle x_{d}}$) as follows:

${\displaystyle N(t,x_{m})=\min\{\ N(t-L_{U}/v_{f},x_{u})\ ,\ N(t+L_{D}/w,x_{d})+k_{j}L_{D}\ \}\qquad (1)}$

where ${\displaystyle L_{U}=x_{m}-x_{u}}$ and ${\displaystyle L_{D}=x_{d}-x_{m}}$.

Goal. Suppose we know the number of vehicles (N) along a boundary in a time-space region and we are looking for the number of vehicles at a generic point P (denoted as ${\displaystyle N_{p}}$) beyond that boundary in the direction of increasing time(see Figure 5).[8]

Suppose, again, that an observer starts moving from the boundary to point P along path L. We know the vehicle number the observer sees, ${\displaystyle N_{L}}$. We then break the path of the observer into small sections (such as the one show between A and B) and note that we also know the maximum number of vehicles that can pass the observer along that small section is, ${\displaystyle C_{AB}}$. The relative capacity formula tells us that it is: ${\displaystyle C_{AB}=r(v^{0})\Delta {t}}$. For TFD and using ${\displaystyle v_{AB}}$ for the slope of segment AB, ${\displaystyle C_{AB}}$ can be written as:

${\displaystyle C_{AB}=r(v_{AB})\Delta {t}=q_{0}\Delta {t}-k_{0}\Delta {x}=q_{0}(t_{B}-t_{A})-k_{0}(x_{B}-x_{A});for\ v_{AB}\in [-w,v_{f}]\qquad (2)}$

So, if we now add the vehicle number on the boundary to the sum of all ${\displaystyle C_{AB}}$ along path L we get an upper bound for ${\displaystyle N_{p}}$. This upper bound applies to any observer that moves with speeds in the range ${\displaystyle [-w,v_{f}]}$. Thus we can write:

${\displaystyle N_{P}\leq N_{L}+\sum _{L}(C_{AB}),\ v_{AB}\in [-w,v_{f}]\qquad (3)}$

Equations (1) and (2) are based on the relative capacity constraint which itself follows from the conservation law.

Maximum principle. It states that ${\displaystyle N_{P}}$ is the largest possible value, subject to the capacity constraints. Thus the VT recipe is:

${\displaystyle N_{P}=\min _{L}\{N_{L}+\sum _{L}(C_{AB})\}\qquad (4)}$

Equation (4) is a shortest path(i.e., calculus of variations) problem with ${\displaystyle C_{AB}=r(v_{AB})}$ as the cost function. It turns out that it produces the same solution as Kinematic wave theory.

 Three steps:
 1. Find the minimum upstream count, ${\displaystyle N_{U}}$
 2. Find the minimum downstream count, ${\displaystyle N_{D}}$
 3. Choose the lower of the two, ${\displaystyle N_{P}=\min\{N_{U}\ ,\ N_{D}\}}$

• Fundamental diagram of traffic flow
• Microscopic traffic flow model
• Microsimulation
• Newell's Car Following Model
• Road traffic control
• Rule 184
• Traffic bottleneck
• Traffic counter
• Traffic flow
• Traffic wave