Tire-pressure gauge

A tire-pressure gauge, or tyre-pressure gauge, is a pressure gauge used to measure the pressure of tires on a vehicle. Tire-pressure gauges can be used both professionally and casually and come in many different sizes.

A tire-pressure gauge displaying bar (outside) and psi (inside)

Since tires are rated for specific loads at certain pressure, it is important to keep the pressure of the tire at the optimal amount. The precision of a typical mechanical gauge as shown is ±3 psi (21 kPa). Higher precision gauges with ±1 psi (6.9 kPa) uncertainty can also be obtained.

Tire-pressure monitoring systems

Many modern cars now come with built-in tire pressure sensors that allow all four tire pressures to be read simultaneously from inside the car. Before 2005, most on-board tire-pressure monitoring systems (TPMS) used indirect pressure monitoring. The anti-lock brake sensors detect one tire rotating faster than the rest and indicate a low tire pressure to the driver. The problem with this method was that if tires all lost the same pressure then none would show up against the others to indicate a problem. However, research have shown that both direct and indirect tire pressure monitoring systems are equally effective.[1]

Regulations on tire pressure

Since September 2007 all new automobiles below 10,000 lb (4,500 kg) in weight sold in the United States are required to incorporate a Tire Pressure Monitoring System, which is capable of monitoring all four tires and simultaneously reporting under-inflation of 25 percent of cold placard pressures in any combination of all four tires. TPMS known as Direct TPMS are capable of TREAD Act legislation requiring simultaneous pressure measurement for each tire pressure.[2]

References

This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.