diastole
Physiology
Biology
Physics
Examples of diastole in the following topics:
-
Measuring Blood Pressure
- Measurement of blood pressure includes systolic pressure during cardiac contraction and diastolic pressure during cardiac relaxation.
- It is recorded as two readings: the systolic blood pressure (the top number) occurs during cardiac contraction, and the diastolic blood pressure or resting pressure (the bottom number), occurs between heartbeats when the heart is not actively contracting.
- A normal blood pressure is about 120 mmHg systolic over 80 mmHg diastolic.
- Hypertensive: 140 mmHg and above systolic and 90 mmHg and above diastolic.
- A blood pressure cuff and associated monitor used for determining systolic and diastolic pressures within an artery.
-
Cardiac Cycle
- Every single heartbeat includes three major stages: atrial systole, ventricular systole, and complete cardiac diastole.
- Complete cardiac diastole occurs after systole.
- Thus, there are two types of measurable blood pressure: systolic during contraction and diastolic during relaxation.
- Systolic blood pressure is always higher than diastolic blood pressure, generally presented as a ratio in which systolic blood pressure is over diastolic blood pressure.
- For example, 115/75 mmHg would indicated a systolic blood pressure of 115 mmHg and a diastolic blood pressure or 75 mmHG.
-
Pumps and the Heart
- A complete cardiac cycle is one round of the heart pumping blood and consists of two parts: systole (contraction of the heart muscle) and diastole (relaxation of the heart muscle).
- Blood pressure is produced by the left ventricle contractions.The rhythm of ventricle diastole, often just referred to as diastole, causes the pulse, which can be felt by holding two fingers to the side of the throat.
-
Introduction to Blood Pressure
- Two mechanisms take place in the heart: diastole and systole.
- Diastole is the relaxation of the chambers of the heart and systole is the contraction of the heart chambers.
- Systolic pressure is thus the pressure that your heart emits when blood is forced out of the heart and diastolic pressure is the pressure exerted when the heart is relaxed.
- During each heartbeat, blood pressure varies between a maximum (systolic) and a minimum (diastolic) pressure.
-
Hypertension
- Hypertension is elevated blood pressure, clinically defined as at or greater than 140/90 (systolic/diastolic) mm/Hg.
- Blood pressure involves two measurements, systolic and diastolic, which depend on whether the heart muscle is contracting (systole) or relaxed between beats (diastole).
- Normal blood pressure at rest is within the range of 100-140mmHg systolic (top reading) and 60-90mmHg diastolic (bottom reading).
-
Blood Pressure
- The systolic pressure is defined as the peak pressure in the arteries during the cardiac cycle; the diastolic pressure is the lowest pressure at the resting phase of the cardiac cycle.
- During diastole, the walls return to normal because of their elastic properties.
- The blood pressure of the systole phase and the diastole phase gives the two readings for blood pressure .
- For example, the typical value for a resting, healthy adult is 120/80, which indicates a reading of 120 mm Hg during the systole and 80 mm Hg during diastole.
-
Arterial Blood Pressure
- A person's blood pressure is usually expressed in terms of the systolic pressure over diastolic pressure and is measured in millimeters of mercury (mmHg), for example 140/90.
- In the past, most attention was paid to diastolic pressure, but now we know that both high systolic pressure and high pulse pressure (the numerical difference between systolic and diastolic pressures) are also risk factors for disease.
- In some cases, a decrease in excessive diastolic pressure can actually increase risk, probably due to the increased difference between systolic and diastolic pressures.
- If systolic blood pressure is elevated (>140) with a normal diastolic blood pressure (<90), it is called "isolated systolic hypertension" and may present a health concern.
-
The Cardiac Cycle
- This is followed by a relaxation phase (diastole), where the heart fills with blood .
- (a) During cardiac diastole, the heart muscle is relaxed and blood flows into the heart.
- (c) During atrial diastole, the ventricles contract, forcing blood out of the heart.
-
Checking Circulation
- For each heartbeat, blood pressure varies between systolic and diastolic pressures.
- Diastolic pressure is minimum pressure in the arteries, which occurs near the beginning of the cardiac cycle when the ventricles are filled with blood.
- An example of normal measured values for a resting, healthy adult human is 120 mmHg systolic and 80 mmHg diastolic.
- The cuff pressure is further released until no sound can be heard (fifth Korotkoff sound), at the diastolic arterial pressure.
-
Blood Flow
- Blood velocities in arteries are higher during systole than during diastole.
- One parameter to quantify this difference is pulsatility index (PI), which is equal to the difference between the peak systolic velocity and the minimum diastolic velocity divided by the mean velocity during the cardiac cycle.