Historically, patients most commonly present for evaluation after a fall off of a bicycle onto the involved knee. Patients will present to their primary care physician, pediatrician, or at the emergency department after having trouble with ambulation secondary to pain and knee effusion. As with any injury or fracture, the skin should first be assessed to ensure there is no evidence of open fractures. If there are associated ligamentous injuries, a knee effusion from a hemarthrosis will not be present as there will be a disruption in the capsule, which allows the effusion to dissipate out of the joint.[1] Patients may have laxity with varus/valgus stress that indicates a disruption in the lateral collateral ligament (LCL) or medial collateral ligament (MCL). Anterior and posterior drawer exams can be performed on the knee to assess the laxity of the ACL and PCL, as well as a Lachman's test to evaluate the ACL. The range of motion should also be assessed and is usually decreased/limited secondary to pain. There may also be a positive McMurray indicating a possible meniscal tear. It is important to examine for injuries to the meniscus as there is a high rate of meniscal entrapment with these types of fractures. According to Kocher et al., entrapment of the anterior horn of the medial or lateral meniscus or the intermeniscal ligament is seen in about 26% of cases of type 2 tibial eminence fractures versus 65% of type 3 tibial eminence fractures. 3.8% of patients present with an associated meniscal tear.[5]

Radiographs of the knee should be obtained to assess the knee for bony injury. Fractures through the tibial eminence should be visible on x-ray. MRI and CT can be obtained for further characterization of the injury.[6] These imaging modalities can be used to assess fracture displacement and comminution. MRI allows detailed evaluation of any soft tissue involvement with the injury (meniscal injury, cartilage, ligaments, etc.) and can also identify any pieces of chondral fracture of the tibial spines that have not yet ossified.[4]. A study by Kocher et al., as well as Mitchell et al., showed that in type II and III fractures, there was a high association of meniscal tears as well as meniscal entrapment. Mitchell et al. also found 7% were found to have associated chondral injuries. Mitchel et al. found type III fractures in 8% had an associated chondral injury, 12% had associated meniscal tears, and 52% had a meniscal entrapment.[7]

Based on imaging review, in 1959 the Meyers and McKeever classification was published:

1. Non-displaced fracture (bony apposition)

2. Partially displaced fracture (posterior hinge)

3. Completely displaced - broken down into (A) not rotated, (B) rotated

4. Comminuted (later added by Zaricznyj in 1977)[2]

Classification of these fractures is important as treatment algorithms are based on the amount of displacement and comminution.

Fracture Types

Type 1: Non-operative treatment is in a cylinder cast or knee immobilizer in a position of comfort (either about 20 degrees of flexion or full extension). Consider drainage of hemarthrosis for symptomatic relief. Keep the knee immobilized for 6 to 12 weeks (once radiographic union) and then transition to weight-bearing and range of motion.[2]

Hemarthrosis drainage can also be considered in cases where closed reduction will be performed to assist in reduction.

Type 2 and 3: Treatment is controversial. There is increasing popularity for reduction and internal fixation. Arthroscopic excision of the fracture fragment is also a possible consideration. Consideration for non-operative management can be used for type 2 fractures when a successful closed reduction is performed. If displacement is still present after closed reduction, this can cause issues with obtaining full extension due to impingement in the femoral notch, and operative management should be pursued. In fractures where there is any intra-articular extension, surgical intervention should be considered.[2][1]

Type 3 and 4: Historically, open reduction and internal fixation of type 3 and 4 fractures were performed through a knee arthrotomy. Due to advances in knee arthroscopy, many recommend arthroscopic reduction and internal fixation of these fracture types. Some combine arthroscopy with arthrotomy to first characterize concomitant intra-articular soft tissue injuries and then perform an arthrotomy to perform internal fixation of the fracture. Performing the entire procedure arthroscopically can be technically challenging, but leads to less soft tissue damage. Arthroscopic fixation is usually by screw or suture after fracture hematoma debridement. Any interposed soft tissue is removed or debrided. Due to the age of the patient population involved, the surgeon must be careful not to disrupt the tibial physis.[1]

Surgical Fixation Techniques

Suture fixation: The benefit of using suture fixation for fracture fixation is there is no need for future hardware removal; however, the technique is technically difficult. First, the tibial tunnel at the ACL footprint is made. Next, the ACL is addressed. There are various ways to perform the technique and a wide variety of devices on the market. Using synthetic absorbable monofilament suture or braided, non-absorbable, monofilament, surgical, single stitch versus a whipstitch is put into the ACL. Absorbable sutures are preferred due to the theoretical tethering of the physis with permanent suture. Metalic sutures can also be used and removed outpatient once there is evidence of radiographic fracture healing in the office. After a stitch is placed through the ACL, the ends of the suture are pulled through the tibial tunnel, and the knee is extended while applying tension to reduce the fragment. The suture is then tied over the bony bridge. Some surgeons use a bone-tendon-bone fixation device to hold temporary fixation to hold reduction prior to tensioning.[8] This is a good technique to consider for comminuted fractures or fractures that are too small for screw fixation as the suture through the ACL can capture these small pieces. If the fragment is big enough, the suture can be passed through the fragment. This technique avoids placing hardware across the physis.[1][9]

Screw Fixation: There are two options with screw fixation: it can be placed either anterograde or retrograde. Cannulated screws are more popular for fixation due to the ease of correct placement. There has been a trend toward suture fixation due to the risk of hardware irritation and the possible need for repeat surgery for screw removal. If screws are not placed deep enough, they can cause issues with impingement or damage the articular cartilage. With screw fixation, there is also a concern for growth disturbance when crossing the tibial physis. The size of the fractured piece also limits screw fixation.

-Anterograde fixation: First, reduce the fracture. Next, flex the knee to 90 degrees, and, using the anteromedial portal, insert the guidewire superoanterior to inferoposterior. Last, place a cannulated screw over the guidewire to fixate the fracture.

-Retrograde fixation: Considered to be less invasive. The fragment must be greater than 15 mm in size to obtain a good purchase. The guidewire should be inserted through the anterior tibial cortex and directed toward tibial eminence. The cannulated screw should be placed over the guidewire, and the fracture fixated.

Comparing the two techniques for fixation, screws provide a more rigid fixation; however, using 3 No.2 multi-strand, long-chain ultra-high molecular weight polyethylene sutures has a higher load to failure than cannulated screw fixation. Studies looking at cyclic loading of constructs comparing screw fixation versus suture fixation have shown that suture fixation has greater strength.[1]

ACL tear, meniscal tear, LCL or MCL sprain, patella fracture, osteochondral fragment, femoral condyle fracture, tibial plateau fracture.

Differential diagnosis can be ruled in or out by obtaining radiographs of the knee and using further diagnostic imaging such as CT or MRI to assist in the diagnosis.

1959 the Meyers and McKeever Classification was published:

1. Non-displaced fracture (bony apposition)

2. Partially displaced fracture (posterior hinge)

3. Completely displaced - broken down into (A) not rotated, (B) rotated

4. Comminuted (later added by Zaricznyj in 1977)[2]

In displaced fractures, without surgical intervention, there is a high incidence of knee instability.[10] In a study by Pailhe et al., there were better functional outcomes in patients treated surgically. Patients who undergo surgical reduction and internal fixation generally have good results with an average Lysholm score of 84.6. 81% of patients had satisfactory to very satisfied results when asked. Return to sporting activities was 20 weeks in this study.[11] In regards to patients treated with arthroscopic reduction internal fixation versus open reduction internal fixation, a study performed by Pailhe et al. showed no difference in patient outcomes. They also found no difference in patients treated with screw fixation versus suture fixation.[11]

Complications that can be encountered with this type of fracture can include loss of motion, malunion, disuse quadriceps atrophy, nonunion, physeal disruption/growth disturbance (recurvatum deformity, distal femoral valgus deformity, limb length discrepancy), laxity, hardware irritation/impingement (most common with metal suture and screw fixation), mechanical impingement, arthrofibrosis, chondral injury.[1]

Another complication that can occur is interposed soft tissue within the fracture site. This can impede fracture reduction and prevent fracture healing or lead to malunion and subsequent impingement of the malreduced fracture. Soft tissue that can become interposed includes the transverse intermeniscal ligament and the anterior horn of the medial or lateral meniscus.

In regards to arthrofibrosis after surgical management, Watts et al. found there was no difference in the incidence based on the surgical approach independently; however, they found in their study that patients that underwent arthroscopic fixation had more risk factors for arthrofibrosis (time to referral to a pediatric orthopedic surgeon who performs the technique, length of surgery).  Watts et al. advocated that time to surgery greater than 7 days from injury and that prolonged operative time greater than 120 minutes put patients at an increased risk for arthrofibrosis.[12] 

Each surgeon has a different postoperative protocol. For non-displaced fractures, immobilization should be for 6 weeks or until evidence of radiographic fracture union for type 1 tibial eminence fractures. Isometric closed chain hamstring and quadricep exercises should be introduced early in rehab to prevent atrophy. Fractures treated surgically are at increased risk for stiffness, so early range of motion is important. Early range of motion is determined on a patient to patient basis.[1] For postoperative rehabilitation, the knee should be immobilized in extension for 2 weeks, with a gradual range of motion being initiated at this time. Partial weight-bearing is allowed at two weeks with crutches. Quadriceps exercises should be initiated at all time points after surgery to avoid atrophy postoperatively.[8]

It is essential to educate the patient and family on the possibility of growth disturbance with fixation of these fractures. Patients and families should be educated on the complications of surgery, including possible secondary surgery for hardware irritation, surgeries related to growth disturbances, the possibility of leg length inequality, risk of infection, risk of damage to surrounding structures, and possible non-union. The importance of postoperative rehabilitation should be emphasized to avoid complications from delayed motion due to patient pain tolerance. Patients should be educated about the risk of arthrofibrosis and quadriceps atrophy and the importance of working hard with physical therapy to get motion and strength back. It is also important to educate the patient and family that there may still be knee instability after treatment as the injury itself can stretch the fibers of the ACL and cause elongation of the fibers.[4]

Appropriate diagnosis and evaluation of patients with tibial eminence fractures are important to provide the best care for patients. Delay in treatment can lead to further injury to other structures within the knee. Primary care, pediatric, and emergency department physicians need to recognize this injury and to refer the patient appropriately for further treatment. Associated injuries should be recognized early to allow earlier evaluation to optimize treatment. For non-operative treatment, communicating appropriate cast care to caregivers and nursing is important to avoid any skin related complications from casting. Proper directions regarding weight-bearing status are important regarding any physical or occupational therapy the patient receives during their fracture rehabilitation. Communicating with the patient and the interprofessional team's expectations of treatment is important to optimize treatment and to address all concerns that may arise for the patient.