0

So as I said, I do not have an actual display or monitor for my raspberry pi 3. That's why I wanted to use an old android phone (htc desire 500) as a display.

That for I followed a tutorial (very serious though) --> http://joshuawoehlke.com/android-raspberry-pi-display-over-usb/

I rigourusly followed every single step of it, but finally, as I started the vnc viewer at 192.168.42.42:1 , it never asked for my password.

It just continued to connect until the natural error dialog error : connection timedout appeared. So Guys, if any of you has ever tried this, it would be really nice if you could help me out, because without a proper display i can't even begin my PI Project

Shan-Desai
  • 1,463
  • 2
  • 12
  • 28
David Colonna
  • 1
  • first step to debug would be to ping your android from pi and vice versa, then telnet into it, and see if theres a VNC service running on Port 5900... my guess is that the tutorial misses a few steps regarding the configuration of the android device ip on the usb interface – Gotschi Aug 09 '16 at 11:39
  • have you enabled ssh using `sudo raspi-config` ? – Shan-Desai Aug 09 '16 at 12:19
  • no i didn't but thanks for the reminder – David Colonna Aug 09 '16 at 13:35

1 Answers1

1

The tutorial you posted is obsolete.

See Start VNC on Jessie at boot

Also the method of setting a static IP won't work see How do I set up networking/WiFi/Static IP

Community
  • 1
Milliways
  • 54,718
  • 26
  • 92
  • 182