Bavarian A II

The Bavarian A II engines were early German 2-2-2 steam locomotives with the Royal Bavarian State Railways (Königlich Bayerische Staatsbahn).

Bavarian A II
Type and origin
BuilderKessler, Maffei
Build date1847–1848
Total produced13
Specifications
Configuration:
  Whyte2-2-2
Gauge1,435 mm (4 ft 8+12 in)
Leading dia.915 mm (3 ft 0 in)
Driver dia.1,524 mm (5 ft 0 in)
Trailing dia.915 mm (3 ft 0 in)
Length:
  Over beams12,496 mm (41 ft 0 in)
Axle load7.6 t (7.5 long tons; 8.4 short tons)
Adhesive weight7.6 t (7.5 long tons; 8.4 short tons)
Service weight21.8 t (21.5 long tons; 24.0 short tons)
Water cap.4.2 m3 (920 imp gal; 1,100 US gal)
Boiler pressure6 kgf/cm2 (588 kPa; 85.3 lbf/in2)
Heating surface:
  Firebox
0.83 m2 (8.9 sq ft)
  Evaporative71.00 m2 (764.2 sq ft)
Cylinders2
Cylinder size318 mm (12+12 in)
Piston stroke559 mm (22 in)
Performance figures
Maximum speed45 km/h (28 mph)
Career
NumbersNames and inventory nos.
Retiredby 1877 (some were converted)

The locomotives were conceived as Stephenson Long Boiler engines. They had an inside forked frame and the firebox was supported by the trailing axle. The only difference between the engines from the two manufacturers was the location of the feed pump. On the Kessler variant this was on the outside and driven by crank pins; on the Maffei version they were suspended from the reverse eccentric cam (Rückwärtsexzenter).

After it was discovered that the riding qualities of the loco were very rough, the trailing axle was moved about 127 mm (5.0 in) further back. In the 1860s the old boiler on some vehicles was replaced by a Crampton boiler. In addition, six engines were rebuilt with a wheel arrangement of 0-6-0 and three into 0-4-2 locomotives. The remainder were taken out of service between 1871 and 1877 and scrapped.

They were coupled with 2 T 4.2 tenders.

See also

This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.