Dry well

A dry well or drywell is an underground structure that disposes of unwanted water, most commonly surface runoff and stormwater, in some cases greywater or water used in a groundwater heat pump. It is a gravity-fed, vertical underground system that can capture surface water from impervious surfaces, then store and gradually infiltrate the water into the groundwater aquifer.

For the nuclear containment structure, see Containment building § Boiling water reactors.
Old drywell

Such structures are also called a dead well, absorbing well, negative well and soakaway or soakage pit in the United Kingdom[1] or a soakwell or soak pit in Australia.[2][3]

Design
Polypropylene soakwell in Perth, Western Australia

Dry wells are excavated pits that may be filled with aggregate or air and are often lined with a perforated casing. The casings consist of perforated chambers made out of plastic or concrete and may be lined with geotextile.[4] They provide high stormwater infiltration capacity while also having a relatively small footprint.[5]

A dry well receives water from entry pipes at its top. It can be used part of a broader stormwater drainage network or on smaller scales such as collecting stormwater from building roofs. It is used in conjunction with pretreatment measures such as bioswales or sediment chambers to prevent groundwater contamination.[6][2]

The depth of the dry well allows the water to penetrate soil layers with poor infiltration such as clays into more permeable layers of the vadose zone such as sand.[7][8]

Simple dry wells consist of a pit filled with gravel, riprap, rubble, or other debris. Such pits resist collapse but do not have much storage capacity because their interior volume is mostly filled by stone. A more advanced dry well defines a large interior storage volume by a concrete or plastic chamber with perforated sides and bottom. These dry wells are usually buried completely so that they do not take up any land area. The dry wells for a parking lot's storm drains are usually buried below the same parking lot.

A sump in a basement can be built in dry well form, allowing the sump pump to cycle less frequently (handling only occasional peak demand). A French drain can resemble a horizontal dry well that is not covered. A larger open pit or artificial swale that receives stormwater and dissipates it into the ground is called an infiltration basin or recharge basin. In places where the amount of water to be dispersed is not as large, a rain garden can be used instead.

A covered pit that disposes of the water component of sewage by the same principle as a dry well is called a cesspool. A septic drain field operates on the same slow-drain/large-area principle as an infiltration basin.

See also

References
  1. "Permeable surfacing of front gardens: guidance". GOV.UK. Ministry of Housing, Communities & Local Government. Retrieved 5 February 2022.
  2. Davis, Jacques. "Environmentalist". Perth Soakwells Pty Ltd. Retrieved 13 March 2016.
  3. "Stormwater". Mornington Peninsula Shire. Retrieved 5 February 2022.
  4. Godwin, Derek; Cahill, Maria; Tilt, Jenna. "Drywells: Low-impact development fact sheet". Oregon State Extension Services. Retrieved 5 February 2022.
  5. "California Drywell Guidance Research and Recommendations" (PDF). California Water Resources Control Board. Retrieved 6 February 2022.
  6. Edwards, Emily; Washburn, Barbara; Lock, Bennett; Mandler, Ben (18 June 2019). "Dry wells for stormwater management". American Geosciences Institute. Retrieved 6 February 2022.
  7. "Low Impact Development (LID)". Los Angeles County Department of Public Works. Retrieved 5 February 2022.
  8. "Dry Wells: Uses, Regulations, and Guidelines in California and Elsewhere" (PDF). California State Water Resources Control Board. Retrieved 6 February 2022.
This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.