EMD FP45

The EMD SDP45 was a good passenger locomotive, but to the Santa Fe Railway it did not look the part. EMD therefore designed a lightweight "cowl" body to cover the locomotive, though it did not, as in earlier cab units, provide any structural strength, which remained in the frame. The cowl provided sleeker looks, better aerodynamics at speed, and allowed the crew to enter the engine compartment en route for diagnostics and maintenance. Final drive gear ratio for passenger service was 57:20.[1]

Santa Fe purchased nine of the locomotives (road numbers 100 through 108), and the Milwaukee Road bought five for its passenger service (road numbers 1 through 5). The Milwaukee Road units were delivered without dynamic braking. Reportedly, Illinois Central Railroad was considering an order for five FP45s as well (EMD order #5742, serial #s 34952–34956), but canceled it. Such low production was feasible and profitable for EMD since the locomotive was fundamentally just a re-clothed SDP45. Power, as in the SDP45, was from a V20 645E3 engine (or prime mover) developing 3,600 hp (2,680 kW).

ATSF 100 and 102 with the Super C in January 1968

Control stand of ATSF 108

A freight-only derivative, the EMD F45, was sold in greater numbers (86) to Santa Fe, the Great Northern Railway, and the Burlington Northern Railroad. Amtrak bought a similar passenger locomotive based on the 3,000 hp (2,240 kW) SD40-2, the SDP40F. After the failure of the SDP40F, Amtrak traded 18 units to the Santa Fe, where they were converted for freight use. The converted locomotives were designated as SDF40-2.

The last three F45s in service were on the Montana Rail Link and the New York, Susquehanna and Western Railway in the northern and northeastern United States. These units were taken out of service in 2006 for the MRL and 2010 for the NYSW. Three are known to survive, with one located at the Izaak Walton Inn, now converted into a lodge.

Between April 1980 and December 1982, Santa Fe's San Bernardino shops rebuilt eight FP45s 5940–5943, 5945–5948. They emerged as 5990–5993, 5995–5998, and were redesignated SDFP45s. The 5944 was retired in September 1981 on account of a wreck at Toland, Texas. Electrically they were upgraded to SD45-2 standards. Mechanically, they were re-geared from 59:18 to 60:17, reducing their top speed from 89 to 83 mph (143 to 134 km/h).

In the mid-1980s Santa Fe again re-geared them - this time to 62:15 for 71 mph (114 km/h).

Milwaukee Road's FP45s were all sold for scrap in 1981 and 1984. Santa Fe SDFP45 No. 5944 was wrecked in 1981, Santa Fe SDFP45 No. 96 was wrecked in 1994 on Cajon Pass. While No. 91 was sold to the Wisconsin Central in January 1995, becoming their #6652 and the rest stayed in service right up until the BNSF merger in 1996, and were retired shortly after the merger.

Those that were not wrecked in service, or sold to other railroads, are on display in museums:

• Santa Fe 90: was donated to the Oklahoma Railway Museum in Oklahoma City in a non-operational state. #90 was the last FP45 donated by the Santa Fe and had resided on a RIP track for two years before being delivered to the museum.
• Santa Fe 92: was donated to the Illinois Railway Museum in Union, Illinois. In 2010, volunteers restored 92's control stand so that it could control other locomotives via MU. The locomotive was moved to National Railway Equipment in Silvis, IL during July 2017, where a replacement 20-645E3 engine, AR10 alternator, and a WBO air compressor (all purchased by the museum) were installed. This made the locomotive fully operational for the first time since at least 1997.
• Santa Fe 93: preserved at the Great Plains Transportation Museum in Wichita, Kansas. It was delivered in June 1999 and has recently undergone cosmetic restoration. A further restoration is planned.[2]
• Santa Fe 95: preserved at the Western America Railroad Museum in Barstow, California.
• Santa Fe 97: preserved at the Museum of the American Railroad in Frisco, Texas. Currently under restoration.
• Santa Fe 108: was donated in operating condition minus the cab's air conditioner to the Southern California Railway Museum at Perris, California. This locomotive has the distinction of being the last passenger locomotive ever purchased by Santa Fe. Its restoration was completed in October, 2018 and it is now in operating condition for the first time since 2012.

• EMD SDP40F - A derivative of the FP45 produced for Amtrak
• GE U30CG - A cowl-bodied passenger variant of the GE U30C, also ordered by the ATSF

• Moran, Miles (1975). "And Passenger Service Too". Railroad Modeler. 5 (8): 40–47.
• Duke, Donald (1997). Santa Fe: The Railroad Gateway to the American West, Volume Two. San Marino, CA: Golden West Books. ISBN 0-87095-110-6.
• Graham-White, Sean (2002). Electro-Motive Division's Classic Cowl Units - A Color Pictorial. La Mirada, CA: Four Ways West. ISBN 1-885614-53-5.
• "5700 Order Numbers". The UNofficial EMD Homepage. Retrieved 2009-06-21.

Wikimedia Commons has media related to EMD FP45 locomotives.

• Additional photos, specifications and information on the surviving FP45 locomotives-by Jim Fuhrman
• Santa Fe 92 at IRM as preserved at IRM
• Preservation project for Santa Fe FP-45 93 At the Great Plains Transportation Museum.