Fiat Twin Cam engine

The Twin Cam uses the block of the overhead valve 124-series engine first found in the Fiat 124 with some modifications to accept the belt drive for the double overhead camshafts (DOHC). The head itself is made in three pieces, one carrying the combustion chamber and valves and one separate casting for each camshaft in tunnel type bearings. The valves had an included angle of 65 degrees. The engine featured a revolutionary new method for adjusting the valve clearance. Usually at that time in double overhead camshaft engines like from Alfa Romeo or Jaguar, small shims were placed on the valve stem inside the bucket tappets, thereby necessitating the removal of the camshafts to get access to these shims to adjust the valve clearance, making for time consuming and very expensive maintenance work. Lampredi’s design placed the shims on top of the tappets where they could be removed with the camshaft in situ after the tappets were pressed down with a special tool. This design was patented for Fiat and was used in the engines of the 128 and 130, and even the Ferrari/Fiat Dino V6 engine was converted to this system.

Fiat was a pioneer in engine development during the time period, using toothed rubber belt driven camshafts and aluminium alloy heads. Earlier Fiat Twin Cam engines were actually O.S.C.A. designs.

Lampredi's twin cam engine was first seen in the Fiat 124 coupé of late 1966, but was later made available in a large number of cars.

CHT engine in a Fiat Croma

One version was the CHT (for "Controlled High Turbulence"). This version was mainly used in the first generation Fiat Croma and used a special head and intake with auxiliary intake ducts to provide a better fuel and gas mixture under low or partial acceleration.[1] This meant considerably improved fuel mileage.

The Fiat Twin Cam engine has been widely used in motorsport and has been the most successful engine in the history of the World Rally Championship. The World Rally Championship for Manufacturers has been won by Fiat and Lancia, using engines based on the Lampredi Twin Cam engine, for a total of 10 years.

The four valve version made its first appearance in the Group 4 competition version of the Fiat 124 Spider Abarth, where it had 1.8 litres. Group 4 regulations at that time allowed the use of a cylinder head of a "free" design. This engine still used a three-piece cylinder head design with an included valve angle of 46 degrees.

In later years motorsport regulations were changed so that the use of four valve heads was only possible when the homologated cars had four valve heads. Therefore, the homologation series of the Fiat 131 Rally Abarth came with a two-litre version of the four valve engine.

These engines were later used in the mid-engined Lancia 037, where they were supercharged and eventually enlarged to 2.1 litres.

In addition to the titles in the World Rally Championship, the Fiat Twin Cam equipped the Lancia Beta Montecarlo turbo, that won the World Sportscar Championship for two consecutive seasons in 1980-1981.

The Fiat Twin Cam has also been used in hot rods and kit cars, with an aftermarket kit to swap one into the Morris Minor.

Fiat 131 Abarth of Walter Röhrl at 1980 Rallye Sanremo

Constructor	Car used in World Championship	Seasons	Manufacturers' titles
Fiat	Fiat 124 Abarth	1970–1975	—
Lancia	Lancia Beta coupe	1974–1975	—
Fiat	Fiat 131 Abarth	1976–1982	3 (1977, 1978, 1980)
Lancia	Lancia 037	1982–1986	1 (1983)
Lancia	Lancia Delta HF 4WD and Delta Integrale	1987–1993	6 (1987–1992)

• Fiat Pratola Serra modular engines