USS New York (ACR-2)

In 1888, during the 50th Congress, 3.5 million dollars was authorized for the construction of New York.[6] She was designed by the Navy Department.[4] On 28 August 1890, the contract for her construction was awarded to William Cramp & Sons of Philadelphia.

New York as built had a main armament of six 8 in (203 mm)/35 caliber Mark 3 breech-loading rifles in two twin Mark 5 turrets fore and aft and two open single Mark 3 and/or Mark 4 mounts on the sides.[7] Secondary armament was twelve 4 in (102 mm)/40 caliber rapid fire (RF) guns in sponsons along the sides, along with eight 6-pounder (57 mm (2.2 in)) Driggs-Schroeder RF guns, four 1-pounder (37 mm (1.5 in)) Driggs-Schroeder RF guns, and three 14 in (356 mm) torpedo tubes for Howell torpedoes.[2][4][8]

New York, as an armored cruiser, had good protection. The belt was 4 in (102 mm) thick and 9 ft (2.7 m) deep, of which 4 ft (1.2 m) was below the waterline. It was 186 ft (57 m) long, protecting only the machinery spaces.[2][8] The armored deck was 6 in (152 mm) thick on its sloped sides and 3 in (76 mm) in the flat middle amidships, but only 2+1⁄2 in (64 mm) at the ends.[2][8] The original gun turrets had up to 5+1⁄2 in (140 mm) of armor, on 10 in (254 mm) barbettes with 5 in (127 mm) protecting the ammunition hoists.[2][8] The open single 8-inch mounts on the sides were much less protected by 2 in (51 mm) partial barbettes, while the secondary gun sponsons had 4 in (102 mm). The conning tower was 7+1⁄2 in (191 mm) thick.[2][8] During construction, the builder reconfigured New York's boiler arrangement for tighter compartmentation.[8]

New York was a fast armored cruiser with a powerful armament, but the belt armor was thin compared to the first generation of older, slow armored cruisers, which tended to have a thick but narrow-coverage (waterline) belt. The thin side armor was comparable to that of the groundbreaking French armored cruiser Dupuy de Lôme, but the French ship's armor covered a much greater area of the hull.[9][10] New York had a greater number of heavy guns than the French cruiser. The hull protection of both ships was superior to their main rival, the British Blake class, which were the largest cruisers at the time but had no side armor.[11] The British had switched from building armored cruisers to favor very large, first class protected cruisers, and stuck with this policy until after the Diadem class.

Along with having competitive weapons and armor, New York was intended to be relatively fast at 20 knots (37 km/h; 23 mph), and achieved 21 knots (39 km/h; 24 mph) on trials. This was achieved with four triple-expansion engines totaling 16,000 ihp (12,000 kW), two clutched in tandem on each of two shafts.[8] The forward engines could be disconnected to conserve fuel at an economical cruising speed. In the US Navy, only Brooklyn shared this feature, which proved something of a liability in the Battle of Santiago de Cuba when both ships were operating with the forward engines disconnected and did not have time to reconnect them, thus limiting their speed.[12] As built, eight coal-fired cylindrical boilers supplied 160 psi (1,100 kPa) steam to the engines.[2][8]

New York underwent an extensive refit in 1905–1909. Her main guns and turrets were replaced with four 8 in (203 mm)/45 caliber Mark 6 guns in new Mark 12 turrets.[13] The new turrets and barbettes had improved Krupp cemented armor, with up to 6+1⁄2 in (165 mm) on the turrets and 6 in (152 mm)-4 in (102 mm) on the barbettes.[2] The side 8-inch guns and torpedo tubes were removed. The secondary armament was replaced as well, with ten 5 in (127 mm)/50 caliber Mark 6 guns and eight 3 in (76 mm)/50 caliber guns. She also received twelve Babcock & Wilcox boilers and the funnels were extended to improve natural draft through the boilers.[2] A further refit during World War I removed two 5-inch and all of the 3-inch single-purpose guns, adding two 3 in (76 mm)/50 anti-aircraft guns. In 1927 her boilers were reduced to four with two funnels, leaving only 7,700 ihp (5,700 kW).[2][4]

USS New York c. 1899

1898 color illustration of the New York

Assigned to the South Atlantic Squadron, New York departed New York Harbor on 27 December 1893 for Rio de Janeiro, Brazil. Arriving at Taipu Beach in January 1894, she remained there until heading home on 23 March, via Nicaragua and the West Indies. Transferred to the North Atlantic Squadron in August, the cruiser returned to West Indian waters for winter exercises and was commended for her aid during a fire that threatened to destroy Port of Spain, Trinidad.[5]

Returning to New York, New York joined the European Squadron in 1895, and steamed to Kiel, where she represented the United States at the opening of the Kiel Canal. Rejoining the North Atlantic Squadron, she operated off Fort Monroe, Charleston, and New York through 1897.[5]

New York departed Fort Monroe on 17 January 1898 for Key West. After the declaration of the Spanish–American War in April, she steamed to Cuba and bombarded the defenses at Matanzas before joining other American ships at San Juan in May, seeking the Spanish squadron. Not finding them, they bombarded Castillo San Felipe del Morro at San Juan (12 May) before withdrawing. New York then became flagship of Admiral William T. Sampson's squadron, as the American commander planned the campaign against Santiago. However, New York was taking Admiral Sampson to a meeting with Major General William Shafter when the Spanish fleet made its breakout attempt, some of her engines were disconnected which reduced her speed, and she was only able to participate in the closing phases of the battle.[12][16][17] The Battle of Santiago de Cuba on 3 July resulted in complete destruction of the Spanish fleet.[5]

The cruiser sailed for New York on 14 August to receive a warrior's welcome. The next year, she cruised with various state naval militia units to Cuba, Bermuda, Honduras, and Venezuela, and conducted summer tactical operations off New England. On 17 October 1899, she departed New York for Central and South American trouble areas.[5]

New York was transferred to the Asiatic Fleet in 1901, sailing via Gibraltar, Port Said, and Singapore to Cavite, where she became flagship of the Asiatic Fleet. She steamed to Yokohama in July for the unveiling of the memorial to the Perry Expedition. In October, New York visited Samar and other Philippine islands as part of the campaign against insurgents. On 13 March 1902, she got underway for Hong Kong and other Chinese ports. In September, she visited Vladivostok, Russia, then stopped at Korea before returning to San Francisco in November. In 1903, New York transferred to the Pacific Squadron and cruised with it to Ampala, Honduras in February to protect American interests during turbulence there. Steaming via Magdalena Bay, Mexico, the cruiser returned to San Francisco, for a reception for President Theodore Roosevelt. In 1904, New York joined squadron cruises off Panama and Peru, then reported to Puget Sound in June where she became flagship of the Pacific Squadron. In September, she enforced the President's neutrality order during the Russo-Japanese War. New York was at Valparaíso, Chile from 21 December 1904 – 4 January 1905, then sailed to Boston and decommissioned on 31 March for modernization.[5]

Recommissioning on 15 May 1909, New York departed Boston on 25 June for Algiers and Naples, where she joined the Armored Cruiser Squadron on 10 July and sailed with it for home on the 23rd. Operating out of Atlantic and gulf ports for the next year, she went into fleet reserve on 31 December.[5]

In full commission again on 1 April 1910, New York steamed via Gibraltar, Port Said, and Singapore to join the Asiatic Fleet at Manila on 6 August. While stationed in Asiatic waters, she cruised among the Philippine Islands, and ports in China and Japan.[5]

She was renamed Saratoga on 16 February 1911, to make the name "New York" available for the battleship New York (BB-34).[5]

The cruiser spent the next five years in the Far East. Steaming to Bremerton, Washington on 6 February 1916, Saratoga went into reduced commission with the Pacific Reserve Fleet.[5]

As the U.S. drew closer to participation in World War I, Saratoga commissioned in full on 23 April 1917, and joined the Pacific Patrol Force on 7 June. In September, Saratoga steamed to Mexico to counter enemy activity in the troubled country. At Ensenada, Saratoga intercepted and helped to capture a merchantman transporting 32 German agents and several Americans seeking to avoid the draft law.[5]

In November, she transited the Panama Canal, joining the Cruiser Force, Atlantic Fleet at Hampton Roads. Here, she was renamed Rochester on 1 December 1917, to free the name "Saratoga" for the new battlecruiser Saratoga (CC-3) (eventually the aircraft carrier CV-3).[5]

After escorting a convoy to France, Rochester commenced target and defense instruction of armed guard crews, in Chesapeake Bay. In March 1918, she resumed escorting convoys and continued the duty through the end of the war, with Alfred Walton Hinds in command. On her third trip, with convoy HM-58, a U-boat torpedoed the British steamer Atlantian on 9 June. Rochester sped to her aid, but Atlantian sank within five minutes. Other ships closed in, but the submarine was not seen again.[5]

After the Armistice, Rochester served as a transport bringing troops home. In May 1919, she served as flagship of the destroyer squadron guarding the transatlantic flight of the Navy's Curtiss NC seaplanes. On 17 July 1920 she was redesignated with the hull number CA-2 (heavy cruiser) as part of a fleetwide redesignation plan.[18] In the early 1920s, she operated along the east coast.[5]

Early in 1923, Rochester got underway for Guantánamo Bay to begin another period of service off the coasts of Central and South America.[5]

In the summer of 1925, Rochester carried General John J. Pershing and other members of his commission to Arica, Chile to arbitrate the Tacna-Arica dispute and remained there for the rest of the year. In September 1926, she helped bring peace to turbulent Nicaragua and from time to time returned there in the late 1920s.[5]

After a quiet 1927, Rochester relieved the gunboat Tulsa at Corinto in 1928 as Expeditionary Forces directed efforts against bandits in the area. Disturbances boiled over in Haiti in 1929, and opposition to the government was strong; inasmuch as American lives were endangered, Rochester transported the 1st Marine Brigade to Port-au-Prince and Cap-Haïtien. In 1930, Rochester transported the five-man commission sent to investigate the situation. In March, she returned to the area to embark marines and transported them to the U.S. She aided Continental Oil tanker H. W. Bruce, damaged in a collision on 24 May.[5]

USS Rochester docked in Subic Bay, 27 October 1941

In 1931, an earthquake rocked Nicaragua. Rochester was the first relief ship to arrive on the scene and ferried refugees from the area. Bandits took advantage of the chaotic conditions and Rochester steamed to the area to counter their activities.[5]

Rochester departed Balboa on 25 February 1932 for service in the Pacific Fleet. She arrived Shanghai on 27 April, to join the fleet in the Yangtze River in June and remained there until steaming to Cavite, to decommission on 29 April 1933. She would remain moored at the Olongapo Shipyard at Subic Bay for the next eight years. Her name was struck from the Naval Vessel Register on 28 October 1938, and she was scuttled on 24 December 1941 to prevent her capture by the Japanese.[5][19]