2-HYDROXYETHYL METHACRYLATE
ICSC: 1724 |
Ethylene glycol monomethacrylate 2-Propenoic acid, 2-methyl-,2-hydroxiethyl ester HEMA C6H10O3 Molecular mass: 130.1 ICSC # 1724 | CAS # 868-77-9 RTECS # OZ4725000 EC # 607-124-00-X November 13, 2008 Validated |
TYPES OF HAZARD/ EXPOSURE | ACUTE HAZARDS/ SYMPTOMS | PREVENTION | FIRST AID/ |
FIRE | Combustible. | NO open flames. | Water spray. Dry powder. Alcohol-resistant foam. |
EXPLOSION | Above 97°C explosive vapour/air mixtures may be formed. | Above 97°C use a closed system, ventilation. | In case of fire: keep drums, etc., cool by spraying with water. |
EXPOSURE | PREVENT GENERATION OF MISTS! | ||
INHALATION | Cough. Sore throat. | Ventilation (not if powder), local exhaust, or breathing protection. | Fresh air, rest. Refer for medical attention. |
SKIN | Redness. | Protective gloves. Protective clothing. | First rinse with plenty of water, then remove contaminated clothes and rinse again. Refer for medical attention. |
EYES | Redness. | Safety spectacles and eye protection in combination with breathing protection. | First rinse with plenty of water for several minutes (remove contact lenses if easily possible), then take to a doctor. |
INGESTION | Sore throat. Aspiration hazard! | Do not eat, drink, or smoke during work. | Rinse mouth. Do NOT induce vomiting. Give one or two glasses of water to drink. Refer immediately for medical attention. |
SPILLAGE DISPOSAL | STORAGE | PACKAGING & LABELLING | ||
Personal protection: Chemical protection suit, filter respirator for organic gases and vapours. Collect leaking liquid in covered containers. Absorb remaining liquid in sand or inert absorbent and remove to safe place. | Store only if stabilized. Keep in the dark. Cool. Ventilation along the floor. | Note: D Xi symbol R: 36/38-43 S: 2-26-28 Signal: Warning Excl mark-Health haz May be harmful if swallowed Causes skin irritation Causes eye irritation May cause allergic skin reaction May be harmful if swallowed and enters airways | ||
|
2-HYDROXYETHYL METHACRYLATE | ICSC: 1724 |
I |
| |||
PHYSICAL |
| |||
ENVIRONMENTAL | ||||
N O T E S | ||||
Boiling Point cannot be experimentally determined: at 1013 hPa polymerization occurs at elevated temperatures, other boiling point: 67 C at 4.6 hPa. Methacrylates are normally stabilized by addition of phenolic inhibitors during transport and storage. An added stabilizer or inhibitor can influence the toxicological properties of this substance, consult an expert. May cause cross sensitization towards other acrylates. |
ADDITIONAL INFORMATION | |||||
|
IMPORTANT LEGAL NOTICE: | Neither NIOSH, the CEC or the IPCS nor any person acting on behalf of NIOSH, the CEC or the IPCS is responsible for the use which might be made of this information. This card contains the collective views of the IPCS Peer Review Committee and may not reflect in all cases all the detailed requirements included in national legislation on the subject. The user should verify compliance of the cards with the relevant legislation in the country of use. The only modifications made to produce the U.S. version is inclusion of the OSHA PELs, NIOSH RELs and NIOSH IDLH values. |
- Page last reviewed: July 22, 2015
- Page last updated: July 1, 2014
- Content source: