Mining Project: Empirical Guidelines for Longwall Ground Control Design
Principal Investigator |
|
---|---|
Start Date | 10/1/2010 |
End Date | 9/30/2014 |
Objective | To update the database of case histories upon which the Analysis of Longwall Pillar Stability (ALPS) software bases its recommended stability factors. Variables impacting successful pillar design will be re-evaluated. |
Topic Areas | |
Research Summary
Nearly half of all underground coal miners work in longwall mines. These miners face hazards from major roof collapses that can block necessary escape routes and ventilation airways, and from injuries from falls of smaller volumes of rock and coal. Longwall mines depend upon a series of entries for safe access to and emergency egress from the face, and to provide critical ventilation of the working area and mined-out panels. These entries may be as great as 15,000 ft long and subjected to severe abutment pressures. A blockage in any of these entries has significant safety implications for the entire mine. Longwall gateroad stability is critical to prevent tailgate collapses which could lead to fatalities and injuries. Proper pillar design and roof support is critical to stable and safe tailgates.
This project's overall goal was to update the database of case histories upon which the Analysis of Longwall Pillar Stability (ALPS) software bases its recommended stability factors and re-evaluate variables impacting successful pillar design to reflect modern mining scenarios. The project aimed to make an important contribution to the PART (Program Assessment Rating Tool) goals of reducing injuries from ground failures by 25% over 5 years, and reducing both fatalities and injuries from ground failures by 50% in 8 years. The project directly addressed Strategic Goal #6 of the Mining Program Strategic Goals for Intramural Research: Eliminate ground failure fatalities and injuries in the mining industry.
Longwall gateroad stability is critical to prevent tailgate collapses which could lead to fatalities and injuries. Proper pillar design and roof support is critical to stable and safe tailgates. The updated ALPS database will ensure the continued value of the ALPS design software, thus maintaining an important design tool for the mining industry.
At the completion of this project, researchers were unable to update the ALPS database with enough cases to warrant revision to the design software, primarily due to limited industry collaboration. There were too many mines that would not allow NIOSH researchers to either visit the sites, provide the supporting information, or publish their information. NIOSH was able to present at least one case history that supported the need to refine ALPS for specific conditions experienced in certain locations around the country.
See Also
- Analysis and Design Considerations for Superimposed Longwall Gate Roads
- Analysis of Pillar Design Practices and Techniques for U.S. Limestone Mines
- Assessment of Stable and Failed Pillars in Underground Limestone Mines
- Behavior of a Coal Pillar Prone to Burst in the Southern Appalachian Basin of the United States
- The Effects of Roof and Floor Interface Slip on Coal Pillar Behavior
- Evaluation of the Impact of Standing Support on Ground Behavior in Longwall Tailgates
- Multiple-Seam Mining Interactions: Case Histories from the Harris No. 1 Mine
- Pillar Design Issues for Underground Stone Mines
- Proceedings: New Technology for Ground Control in Retreat Mining
- The Unpredictable Life Cycle of a Coal Pillar
- Page last reviewed: 10/22/2016
- Page last updated: 10/22/2016
- Content source: National Institute for Occupational Safety and Health, Mining Program