M6 motorway

The first section of the motorway and the first motorway in the country was the Preston By-pass. It was built by Tarmac Construction and opened by the Prime Minister Harold Macmillan on 5 December 1958.[7] In January 1959 the Preston by-pass was closed because of rapid surface deterioration over a stretch of 100 yards (91 m) "due to water freezing and then thawing". Motorists were diverted to the old road while the UK road research laboratory at Harmondsworth pondered the importance of surface water drainage.[8]

The second phase of construction was completed in 1960, forming the Lancaster by-pass. Some 100 miles (160 km) south, the Stafford by-pass was completed in 1962.[9][10] By 1965, the remaining sections of motorway Stafford–Preston and Preston–Lancaster had been completed. 1966 saw junction 11 to 13 completed. 1968 saw the completion of the Walsall to Stafford link as well as the Penrith by-pass some 150 miles (240 km) north in Cumberland. In 1970, the Lancaster–Penrith link was completed, along with a short section of motorway by-passing the south of Walsall. The most northerly section of the motorway also opened in 1970, running to the designated terminus north of Carlisle. By 1971 the full route was completed between the junction with the M1 motorway at Rugby and the A38 road several miles north-east of Birmingham city centre,[9] including Bromford Viaduct between Castle Bromwich (J5) and Gravelly Hill (J6), which at 3.5 miles (5.6 km) is the longest viaduct in Great Britain.[11][12]

Junction 6 in Birmingham, which opened in May 1972, is widely known as Spaghetti Junction because of its complexity and round and curvy-like design. On the elevated ground between Shap and Tebay, the north and south-bound carriages split apart.[13] At this point a local road (to Scout Green) runs between the two carriageways without a link to the motorway.[14]

The section of the M6 that runs over Shap Fell in Cumbria at Shap Summit is 1,036 ft (316 m) above sea level, one of the highest points on any motorway in the UK (Junction 22 of the M62 on Saddleworth Moor is higher). The motorway engineers here chose to follow the route of the Lancaster and Carlisle Railway engineered by Joseph Locke (now part of the West Coast Main Line) where the motorway runs in a split-level cutting above the railway in the descent from Shap Fell through the Lune Gorge into southern Cumbria.[15]

The northbound entry slip road at Lancaster (Junction 34) was unusually short, presenting problems for traffic joining the motorway. The M6 crosses the River Lune at this point and unless the bridge had been made wider, there was no space to build a longer slip road. This junction was upgraded from an earlier emergency-vehicles-only access point, which explains the substandard design.[16] The construction of the Heysham to M6 Link Road (The Bay Gateway) has completely re-modelled this junction with a wide additional bridge over the River Lune and other works repositioning slip roads with new acceleration lanes to modern standards.

The route was originally intended to replace the old A6, which it does along the northern section starting with the Preston Bypass. However, a much closer approximation to the overall actual route of the M6 (heading north from its southern terminus) is provided by following the A45, A34, A50, A49, then the A6.[17] South of Preston, the A6 route is instead supplemented by the M61 as far as Manchester, with the M60 acting as a bypass around the city. South of Manchester, there is no true motorway replacement for the old road. The M1 acts as a bypass for long-distance traffic in the south, from the Kegworth junction near Nottingham, to Luton and St. Albans near London; but, it is not an alternative for local traffic as the routes diverge by more than 15 miles (24 km) while passing through Northamptonshire. Across the Pennines, the old road remains the main local through-route, and long-distance fast traffic between Derby and Manchester must instead take either the A50 and M6, or M1 and M62.[18]

Once all sections of the motorway were constructed, and it was finally all linked together, the result was an uninterrupted motorway length of 230 miles (370 km).[19][20][21]

The M6 in Cheshire in 1969

In July 1972, the Minister for Transport Industries, John Peyton, announced that 86 miles (138 km) of UK motorway particularly prone to fog would benefit from lighting in a project which "should be" completed by 1973.[22] Sections to be illuminated included the M6 between junctions 10 and 11, and between junctions 20 and 27.[22]

In March 2006, after 15 years of debate,[23] the government authorised the construction of a 6-mile (9.7 km) extension of the M6 from its then northern terminus near Carlisle to the Anglo-Scottish border at Gretna (the so-called "Cumberland Gap"), where it links into the existing A74(M).[24] The road opened on 5 December 2008, the 50th anniversary of the M6 Preston By-pass.[25] The project, which was a mixture of new road and upgrade of the existing A74, crosses the West Coast Main Line and had an estimated costs of £174 million. It completed an uninterrupted motorway from just south of Dunblane (via the M9, the recently opened M80 section near Cumbernauld and the M73) in the north to Exeter (via the M5) and to London (via both the M42/M40 and the M1) in the south.[26]

Burton-in-Kendal[lower-alpha 1]

Charnock Richard

Corley

Hilton Park

Keele

Killington Lake[lower-alpha 2]

Knutsford

Lancaster Forton

Lymm (truckstop)

Norton Canes (M6 Toll)

Rugby

Sandbach

Southwaite

Stafford[lower-alpha 4]

Tebay

Todhills (rest area)

M6 service areas[27]
Operators:  Moto ​ Roadchef ​ Welcome Break ​ Westmorland

The M6 Toll, Britain's first toll motorway, which bypasses the West Midlands conurbation to the east and north of Birmingham and Walsall and was built to alleviate traffic congestion through the West Midlands, opened in December 2003. Before the opening of the toll motorway, this section of the M6 carried 180,000 vehicles per day at its busiest point near Wolverhampton (between the junctions with the M54 and M5 motorways), compared with a design capacity of only 72,000 vehicles. Usage, at about 50,000 vehicles, was lower than expected and traffic levels on the M6 were only slightly reduced as a result. The high toll prices, which were set by the operating company and over which the UK Government has no influence until 2054, were blamed for the low usage.[28] Much traffic continues to use the M6 or the continued on the M1 and took the A50 or A52.[29] As of July 2012 the road between Junctions 3A and 11A now carries 120,000 motor vehicles every day.[30]

A proposed extension to the M6 Toll known as the 'M6 Expressway', which would have continued from the M6 Toll as far as Knutsford, at which point much of the existing M6 traffic leaves the M6 for Manchester, was abandoned in 2006 due to excessive costs, anticipated construction problems[31] and disappointing levels of use of the M6 Toll.

In October 2007, following a successful trial on the M42 in the West Midlands, the government announced that two stretches of the M6 would be upgraded to allow the hard shoulder to be used as a normal running lane during busy conditions under a scheme called active traffic management.[32] The two stretches, between junctions 4 and 5 and between junctions 10a and 8, are two of the busiest sections on the entire motorway.[33] It was then proposed that the system could be extended onto other stretches of the M6 while the government undertook a feasibility study to determine other likely locations for this technology to be used.[34] The stretch between junctions 4 and 5 was completed during December 2009[35] while the stretch between junctions 10a and 8 was completed during March 2011.[36] This was then followed by a stretch between junctions 5 and 8 which started construction in April 2012 and was completed in October 2014.[37]

After plans of the government to improve reliability and capacity between Junctions 11 by Cannock and Junction 19 near Knutsford it favoured a new motorway in 2004, 'The Expressway' following a roughly parallel course to the existing M6.[38][39] In July 2006, the government announced its decision to abandon the Expressway proposal, and favoured widening accompanied by demand-management measures,[31] and launched a study to consider options for providing additional capacity.[40] After the stretch between junction 10a and 13 was upgraded to a managed motorway in February 2016,[41] it was then proposed to introduce a managed motorway between junction 13 and 19,[42] later divided into two separate stretches, between junctions 16 and 19 and junctions 13 and 15.[43] The stretch between junctions 16 and 19 started construction in December 2015[44] and was completed in March 2019[45] while construction on the stretch between junctions 13 and 15 commenced in March 2018[46] and was completed in August 2022.[47]

In April 2021, the M6 gained the first motorway service station to be built for thirteen years. Located off Junction 1 at Rugby and opened on 30 April 2021, the facility, run by Moto Hospitality, includes the largest electric vehicle charging facility in the UK, run by Ecotricity and Gridserve.[48][49]

Work started in 2020 to reconstruct the bridges above the motorway at junction 10, due to frequent congestion at peak times, due to be completed in 2023 at a cost of £78,000,000.[50]

Work started in March 2022 to upgrade the existing Dynamic Hard Shoulder smart motorway to add newer safety features to the motorway, such as a concrete central reservation, new emergency areas and drainage improvements. Currently, this work does not have an end date proposed.[51]

Work started in early 2021 to upgrade the M6 from junction J21A to J26 to the all lane running standard of smart motorway, with an estimated cost of between £100 million - £250 million. The smart motorway is due to be fully open in 2023, but could be delayed until 2024.[52]