Stellar nucleosynthesis

In 1920, Arthur Eddington proposed that stars obtained their energy from nuclear fusion of hydrogen to form helium and also raised the possibility that the heavier elements are produced in stars.

In 1920, Arthur Eddington, on the basis of the precise measurements of atomic masses by F.W. Aston and a preliminary suggestion by Jean Perrin, proposed that stars obtained their energy from nuclear fusion of hydrogen to form helium and raised the possibility that the heavier elements are produced in stars.[6][7][8] This was a preliminary step toward the idea of stellar nucleosynthesis. In 1928 George Gamow derived what is now called the Gamow factor, a quantum-mechanical formula yielding the probability for two contiguous nuclei to overcome the electrostatic Coulomb barrier between them and approach each other closely enough to undergo nuclear reaction due to the strong nuclear force which is effective only at very short distances.[9]^: 410 In the following decade the Gamow factor was used by Atkinson and Houtermans and later by Edward Teller and Gamow himself to derive the rate at which nuclear reactions would occur at the high temperatures believed to exist in stellar interiors.

In 1939, in a Nobel lecture entitled "Energy Production in Stars", Hans Bethe analyzed the different possibilities for reactions by which hydrogen is fused into helium.[10] He defined two processes that he believed to be the sources of energy in stars. The first one, the proton–proton chain reaction, is the dominant energy source in stars with masses up to about the mass of the Sun. The second process, the carbon–nitrogen–oxygen cycle, which was also considered by Carl Friedrich von Weizsäcker in 1938, is more important in more massive main-sequence stars.[11]^: 167 These works concerned the energy generation capable of keeping stars hot. A clear physical description of the proton–proton chain and of the CNO cycle appears in a 1968 textbook.[12]^: 365 Bethe's two papers did not address the creation of heavier nuclei, however. That theory was begun by Fred Hoyle in 1946 with his argument that a collection of very hot nuclei would assemble thermodynamically into iron.[1] Hoyle followed that in 1954 with a paper describing how advanced fusion stages within massive stars would synthesize the elements from carbon to iron in mass.[2][13]

Hoyle's theory was extended to other processes, beginning with the publication of the 1957 review paper "Synthesis of the Elements in Stars" by Burbidge, Burbidge, Fowler and Hoyle, more commonly referred to as the B²FH paper.[3] This review paper collected and refined earlier research into a heavily cited picture that gave promise of accounting for the observed relative abundances of the elements; but it did not itself enlarge Hoyle's 1954 picture for the origin of primary nuclei as much as many assumed, except in the understanding of nucleosynthesis of those elements heavier than iron by neutron capture. Significant improvements were made by Alastair G. W. Cameron and by Donald D. Clayton. In 1957 Cameron presented his own independent approach to nucleosynthesis,[14] informed by Hoyle's example, and introduced computers into time-dependent calculations of evolution of nuclear systems. Clayton calculated the first time-dependent models of the s-process in 1961[15] and of the r-process in 1965,[16] as well as of the burning of silicon into the abundant alpha-particle nuclei and iron-group elements in 1968,[17][18] and discovered radiogenic chronologies[19] for determining the age of the elements.

Cross section of a supergiant showing nucleosynthesis and elements formed.

A version of the periodic table indicating the origins – including stellar nucleosynthesis – of the elements.

The most important reactions in stellar nucleosynthesis:

• Hydrogen fusion:
  • Deuterium fusion
  • The proton–proton chain
  • The carbon–nitrogen–oxygen cycle
• Helium fusion:
  • The triple-alpha process
  • The alpha process
• Fusion of heavier elements:
  • Lithium burning: a process found most commonly in brown dwarfs
  • Carbon-burning process
  • Neon-burning process
  • Oxygen-burning process
  • Silicon-burning process
• Production of elements heavier than iron:
  • Neutron capture:
    • The r-process
    • The s-process
  • Proton capture:
    • The rp-process
    • The p-process
  • Photodisintegration

Hydrogen fusion

Main articles: Proton–proton chain reaction, CNO cycle, and Deuterium fusion

Proton–proton chain reaction

CNO-I cycle
The helium nucleus is released at the top-left step.

Hydrogen fusion (nuclear fusion of four protons to form a helium-4 nucleus[20]) is the dominant process that generates energy in the cores of main-sequence stars. It is also called "hydrogen burning", which should not be confused with the chemical combustion of hydrogen in an oxidizing atmosphere. There are two predominant processes by which stellar hydrogen fusion occurs: proton–proton chain and the carbon–nitrogen–oxygen (CNO) cycle. Ninety percent of all stars, with the exception of white dwarfs, are fusing hydrogen by these two processes.[21]^: 245

In the cores of lower-mass main-sequence stars such as the Sun, the dominant energy production process is the proton–proton chain reaction. This creates a helium-4 nucleus through a sequence of reactions that begin with the fusion of two protons to form a deuterium nucleus (one proton plus one neutron) along with an ejected positron and neutrino.[22] In each complete fusion cycle, the proton–proton chain reaction releases about 26.2 MeV.[22] The proton–proton chain reaction cycle is relatively insensitive to temperature; a 10% rise of temperature would increase energy production by this method by 46%, hence, this hydrogen fusion process can occur in up to a third of the star's radius and occupy half the star's mass. For stars above 35% of the Sun's mass,[23] the energy flux toward the surface is sufficiently low and energy transfer from the core region remains by radiative heat transfer, rather than by convective heat transfer.[24] As a result, there is little mixing of fresh hydrogen into the core or fusion products outward.

In higher-mass stars, the dominant energy production process is the CNO cycle, which is a catalytic cycle that uses nuclei of carbon, nitrogen and oxygen as intermediaries and in the end produces a helium nucleus as with the proton–proton chain.[22] During a complete CNO cycle, 25.0 MeV of energy is released. The difference in energy production of this cycle, compared to the proton–proton chain reaction, is accounted for by the energy lost through neutrino emission.[22] The CNO cycle is very temperature sensitive, a 10% rise of temperature would produce a 350% rise in energy production. About 90% of the CNO cycle energy generation occurs within the inner 15% of the star's mass, hence it is strongly concentrated at the core.[25] This results in such an intense outward energy flux that convective energy transfer becomes more important than does radiative transfer. As a result, the core region becomes a convection zone, which stirs the hydrogen fusion region and keeps it well mixed with the surrounding proton-rich region.[26] This core convection occurs in stars where the CNO cycle contributes more than 20% of the total energy. As the star ages and the core temperature increases, the region occupied by the convection zone slowly shrinks from 20% of the mass down to the inner 8% of the mass.[25] The Sun produces on the order of 1% of its energy from the CNO cycle.[27][lower-alpha 1][28]^: 357[29][lower-alpha 2]

The type of hydrogen fusion process that dominates in a star is determined by the temperature dependency differences between the two reactions. The proton–proton chain reaction starts at temperatures about 4×10⁶ K,[30] making it the dominant fusion mechanism in smaller stars. A self-maintaining CNO chain requires a higher temperature of approximately 16×10⁶ K, but thereafter it increases more rapidly in efficiency as the temperature rises, than does the proton–proton reaction.[31] Above approximately 17×10⁶ K, the CNO cycle becomes the dominant source of energy. This temperature is achieved in the cores of main-sequence stars with at least 1.3 times the mass of the Sun.[32] The Sun itself has a core temperature of about 15.7×10⁶ K.[33]^: 5 As a main-sequence star ages, the core temperature will rise, resulting in a steadily increasing contribution from its CNO cycle.[25]

The reaction rate density between species A and B, having number densities n_A,B, is given by:

${\displaystyle r=n_{A}\,n_{B}\,k}$

where k is the reaction rate constant of each single elementary binary reaction composing the nuclear fusion process:

${\displaystyle k=\langle \sigma (v)\,v\rangle }$

here, σ(v) is the cross-section at relative velocity v, and averaging is performed over all velocities.

Semi-classically, the cross section is proportional to ${\displaystyle \pi \,\lambda ^{2}}$, where ${\displaystyle \lambda =h/p}$ is the de Broglie wavelength. Thus semi-classically the cross section is proportional to ${\textstyle {\frac {m}{E}}}$.

However, since the reaction involves quantum tunneling, there is an exponential damping at low energies that depends on Gamow factor E_G, giving an Arrhenius equation:

${\displaystyle \sigma (E)={\frac {S(E)}{E}}e^{-{\sqrt {\frac {E_{\text{G}}}{E}}}}}$

where S(E) depends on the details of the nuclear interaction, and has the dimension of an energy multiplied for a cross section.

One then integrates over all energies to get the total reaction rate, using the Maxwell–Boltzmann distribution and the relation:

${\displaystyle {\frac {r}{V}}=n_{A}n_{B}\int _{0}^{\infty }{\frac {S(E)}{E}}\,e^{-{\sqrt {\frac {E_{\text{G}}}{E}}}}2{\sqrt {\frac {E}{\pi (kT)^{3}}}}e^{-{\frac {E}{kT}}}\,{\sqrt {\frac {2E}{m_{\text{R}}}}}dE}$

where ${\displaystyle m_{\text{R}}={\frac {m_{1}m_{2}}{m_{1}+m_{2}}}}$ is the reduced mass.

Since this integration has an exponential damping at high energies of the form ${\displaystyle \sim e^{-{\frac {E}{kT}}}}$ and at low energies from the Gamow factor, the integral almost vanished everywhere except around the peak, called Gamow peak,[36]^: 185 at E₀, where:

${\displaystyle {\frac {\partial }{\partial E}}\left(-{\sqrt {\frac {E_{\text{G}}}{E}}}-{\frac {E}{kT}}\right)\,=\,0}$

Thus:

${\displaystyle E_{0}=\left({\frac {1}{2}}kT{\sqrt {E_{\text{G}}}}\right)^{\frac {2}{3}}}$

The exponent can then be approximated around E₀ as:

${\displaystyle e^{-{\frac {E}{kT}}-{\sqrt {\frac {E_{\text{G}}}{E}}}}\approx e^{-{\frac {3E_{0}}{kT}}}\exp \left(-{\frac {(E-E_{0})^{2}}{{\frac {4}{3}}E_{0}kT}}\right)}$

And the reaction rate is approximated as:[37]

${\displaystyle {\frac {r}{V}}\approx n_{A}\,n_{B}\,{\frac {4{\sqrt {2}}}{\sqrt {3m_{\text{R}}}}}\,{\sqrt {E_{0}}}{\frac {S(E_{0})}{kT}}e^{-{\frac {3E_{0}}{kT}}}}$

Values of S(E₀) are typically 10⁻³ – 10³ keV·b, but are damped by a huge factor when involving a beta decay, due to the relation between the intermediate bound state (e.g. diproton) half-life and the beta decay half-life, as in the proton–proton chain reaction. Note that typical core temperatures in main-sequence stars give kT of the order of keV.[38]^{: ch. 3}

Thus, the limiting reaction in the CNO cycle, proton capture by ¹⁴
₇N
, has S(E₀) ~ S(0) = 3.5 keV·b, while the limiting reaction in the proton–proton chain reaction, the creation of deuterium from two protons, has a much lower S(E₀) ~ S(0) = 4×10⁻²² keV·b.[39][40] Incidentally, since the former reaction has a much higher Gamow factor, and due to the relative abundance of elements in typical stars, the two reaction rates are equal at a temperature value that is within the core temperature ranges of main-sequence stars.[41]^: 211

• Bethe, H. A. (1939). "Energy Production in Stars". Physical Review. 55 (1): 541–547. Bibcode:1939PhRv...55..103B. doi:10.1103/PhysRev.55.103. PMID 17835673.
• Bethe, H. A. (1939). "Energy Production in Stars". Physical Review. 55 (5): 434–456. Bibcode:1939PhRv...55..434B. doi:10.1103/PhysRev.55.434. PMID 17835673.
• Hoyle, F. (1954). "On Nuclear Reactions occurring in very hot stars: Synthesis of elements from carbon to nickel". Astrophysical Journal Supplement. 1: 121–146. Bibcode:1954ApJS....1..121H. doi:10.1086/190005.
• Clayton, Donald D. (1968). Principles of Stellar Evolution and Nucleosynthesis. New York: McGraw-Hill.
• Ray, A. (2004). "Stars as thermonuclear reactors: Their fuels and ashes". arXiv:astro-ph/0405568.
• G. Wallerstein; I. Iben, Jr.; P. Parker; A. M. Boesgaard; G. M. Hale; A. E. Champagne; et al. (1997). "Synthesis of the elements in stars: forty years of progress" (PDF). Reviews of Modern Physics. 69 (4): 995–1084. Bibcode:1997RvMP...69..995W. doi:10.1103/RevModPhys.69.995. hdl:2152/61093. Archived from the original (PDF) on 2009-03-26. Retrieved 2006-08-04.
• Woosley, S. E.; A. Heger; T. A. Weaver (2002). "The evolution and explosion of massive stars". Reviews of Modern Physics. 74 (4): 1015–1071. Bibcode:2002RvMP...74.1015W. doi:10.1103/RevModPhys.74.1015. S2CID 55932331.
• Clayton, Donald D. (2003). Handbook of Isotopes in the Cosmos. Cambridge: Cambridge University Press. ISBN 978-0-521-82381-4.
• Iliadis, Christian (2007). Nuclear Physics of Stars. Weinheim: Wiley-VCH. doi:10.1002/9783527618750. ISBN 978-3-527-40602-9.

• "How the Sun Shines", by John N. Bahcall (Nobel prize site, accessed 6 January 2020)
• Nucleosynthesis in NASA's Cosmicopia