Stays (nautical)

Stays are ropes, wires, or rods on sailing vessels that run fore-and-aft along the centerline from the masts to the hull, deck, bowsprit, or to other masts which serve to stabilize the masts.[1]

1 – mainsail Edit this on Wikidata 2 – staysail Edit this on Wikidata 3 – spinnaker Edit this on Wikidata
4 – hull Edit this on Wikidata 5 – keel Edit this on Wikidata 6 – rudder Edit this on Wikidata 7 – skeg Edit this on Wikidata
8 – mast Edit this on Wikidata 9 – Spreader Edit this on Wikidata 10 – shroud Edit this on Wikidata
11 – sheet Edit this on Wikidata 12 – boom Edit this on Wikidata 13 - mast Edit this on Wikidata
14 – spinnaker pole Edit this on Wikidata 15 – backstay Edit this on Wikidata
16 – forestay Edit this on Wikidata 17 – boom vang Edit this on Wikidata

A stay is part of the standing rigging and is used to support the weight of a mast.

It is a large strong rope extending from the upper end of each mast and running down towards the deck of the vessel in a midships fore and aft direction.

The shrouds serve a similar function but extend on each side of the mast and provide support in the athwartships direction. The object of both is to prevent the masts from falling down but the stays also prevent springing, when the ship is pitching deep.

Thus stays are fore and aft. Those led aft towards the vessel's stern are backstays while those that lead forward towards the bow are forestays.

"To stay" is also a verb: to bring the ship's head up to the wind (to point the bow upwind).[2] This is done in order to go about (to tack; tacking is sometimes also called staying the vessel[3]); the bow of the ship turns upwind, then continues turning until the wind comes over the other side. To miss stays is to fail in the attempt to go about;[4] if the vessel fails to go about, she is said to refuse stays.[3] In stays, or hove in stays, is the situation of a vessel when she is staying, or in the act of going about.[4] A vessel in bad trim, or lubberly-handled, is sure to be slack or loose in the stays: she may refuse stays fairly often. A suitable vessel well-handled can usually be stayed swiftly, without losing noticeable way (without slowing down), and the sails will go over gently and without fuss or overshooting.[3][4]

Types of stays

forestay or headstay
reaches from the foremast-head towards the bowsprit end
mainstay
extends to the ship's stem. The mizzenstay stretches to a collar on the main-mast, immediately above the quarter-deck.
fore-topmast stay
goes to the end of the bowsprit, a little beyond the forestay, on which the fore-topmast staysail runs on hanks.
main-topmast stay
attaches to the hounds of the foremast, or comes on deck.
mizzen-topmast stay
goes to the hounds of the main-mast.
top-gallant, royal, or any other masts
have each a stay, named after their respective masts
springstay
is a kind of substitute nearly parallel to the principal stay, and intended to help the principal stay to support its mast
triatic stay
is a stay that runs between masts. On a ketch it runs between the main mast and the head of the mizzen mast and is used to stop the upper section of the mizzen mast being pulled backwards. On a steamer, an iron bar between the two knees secures the paddle-beams. (See funnel stays).

See also

References

  1. Keegan, John (1989). The Price of Admiralty. New York: Viking. p. 280. ISBN 0-670-81416-4.
  2. The Elements and Practice of Rigging And Seamanship. London. 1793.
  3. "WORKING TO WINDWARD". Text-Book of Seamanship. 1891. {{cite book}}: |website= ignored (help)
  4. Smyth, William Henry; Belcher, Edward (1867). The sailor's word-book: An alphabetical digest of nautical terms, including some more especially military and scientific ... as well as archaisms of early voyagers, etc. London: Blackie and Son. pp. 652–653. Archived from the original on 2009-02-17.
This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.