How to Drive a Manual Transmission Vehicle Without Using the Clutch

Last Updated: January 22, 2023

In most manual transmission vehicles it is possible to shift gears without use of the clutch. This is done by matching the engine output RPM with the rotational speed of the vehicle's transmission output. Please note that this can only be done when the vehicle is in motion, the clutch must be used when starting from a dead stop.

Method 1

Method 1 of 2:

To Upshift

1
When the car is in motion and when the current gear is in shifting range, take your foot off the accelerator. This will relieve the tension in the transmission. Immediately afterwards, pull the shift lever out of gear.^{[1]
X
Research source}
2
Push (or pull) the shift lever in the direction of the desired gear, applying light pressure against the desired gear. (NOTE: The amount of pressure required can vary: Too much pressure and the gear can slip in prematurely, resulting in gear grinding. Too little pressure and the gear won't slip in all the way, resulting in gear grinding).^{[2]
X
Research source}

Advertisement
3
Once the engine RPMs have dropped to match the rotational speed of the transmission output, the shift lever should slip into gear.^{[3]
X
Research source}
4
Once the car is in gear again, you can continue normal driving.

Method 2

Method 2 of 2:

To Downshift

1
When the car is in motion and when the current gear is too low to maintain proper power, take your foot off the accelerator and then pull the shift lever out of gear.^{[4]
X
Research source}
2
Lightly tap on the accelerator once to raise the engine's RPMs to around 2000-2500 (depends on the transmission).^{[5]
X
Research source}
3
While the engine RPMs are dropping, push (or pull) the shift lever in the direction of the desired gear, applying light pressure against the desired gear.
- Once the engine RPMs have matched the rotational speed of the transmission output, the shift lever should slip into gear.^{[6]
  X
  Research source}
4
Once the car is in gear again, you can continue normal driving.

Community Q&A

Question

Will this technique damage my cars transmission?

Community Answer

Yes, it can damage your transmission if you do not do it properly.
Question

When do I need to use the fifth gear?

Community Answer

On the highway, your highest gear is optimal. When merging onto another highway, downshifting is a good idea so that you can accelerate faster with the higher RPM.
Question

Will this damage my transmission?

Community Answer

Not if you match the RPMs correctly. If the gears grind then you should just continue with the clutch.

Warnings

This can ONLY be done when the vehicle is already in motion. Starting a manual transmission vehicle from a dead stop requires the use of the clutch.

⧼thumbs_response⧽
Helpful 26 Not Helpful 13
When downshifting without the clutch, make sure that you let the engine RPMs start to fall before applying pressure against the gear. If you apply pressure beforehand, the gear may attempt to slip in prematurely, resulting in gear grinding.

⧼thumbs_response⧽
Helpful 28 Not Helpful 15
Please note that not all transmissions are "smooth" enough to be shifted without use of the clutch, repeated attempts to do so may damage the transmission if gear grinding is excessive. Some heavier duty transmissions tend to grind gears much more easily and are more difficult to shift without use of the clutch. This is most easily attempted on light duty transmissions such as those in compact/mid-sized cars/SUVs/trucks.

⧼thumbs_response⧽
Helpful 17 Not Helpful 8