MP 73

After equipping line 4 with rolling stock (MP 59), the RATP considered the conversion of iron lines to tires to be too long and costly to be completed within a timeframe compatible with the replacement of the oldest rolling stock. The RATP then developed modern iron-based equipment, the MF 67, in order to quickly replace the old Sprague-Thomson trainsets. However, line 6 of the metro having an aerial route over almost half of its length, it is again equipment on tires that is chosen, in order to limit noise and vibrations with regard to local residents.[2]

This new equipment, named MP 73, has a different appearance from the other series of equipment on tires, with angular faces similar to the MF 67. The MP73 was first released with a livery consisting of strong blue at the bottom of the body, and light gray at the top in order to better withstand pressure washing as well as the constraints of a largely outdoor operation.[3] The interior was uniformly very light grey. However, they were since repainted with blue, green and yellow interiors and the standard RATP paint on the outside. The MP73 trains have five cars, two of which are motor cars with driver's cabins, one motor car without a cabin, and two standard passenger cars. The bogies are equipped with “ZZ” ribbed tires to improve grip on outdoor sections of the track in rainy weather.

The fifty MP 73 trainsets built in 1974 were put into service between July 1 and July 31, 1974. They are particularly appreciated by local residents for their much lower noise levels than the old iron wheel trains they replace: According to the measurements taken on the viaducts during commissioning, at equal speed and at the height of the first floor of the buildings, the MP 73 reaches 67.5 dB(A) against 80 dB(A) for the Sprague-Thomson trains. Inside the trains, the noise measured also drops sharply, from 82 to 64 dB(A).[4]

Until 1975, the MP73s ran alongside the few remaining Sprague-Thomson trains on line 6. Some MP73 trains were transferred to reinforce line 4 (until 1979) and line 11 (until 1999).

• on line 4, they ran alongside the MP 59 rubber-tired trainsets and were lengthened to six cars like the MP 59s on this line from 1976 to 1979; Train 6550 (M3599-N4550-A6550-B7050-?-M3600) traveled on this line in the company of another MP 73 train, also with six cars;
• on line 11 in 1976 and 1978,[5] they appeared with the MP 55, the first rubber-tired trains built between 1956 and 1958, and like the latter with four cars.

The MP 73 did not originally have glazing on interior doors and articulations. The glazing was put in place afterwards to reduce vandalism and improve durability.

From 1996, the RATP undertook the renovation of the MP 73 trains. The first renovated train was 6529 (M.3557-B.7029-A.6529-N.4529-M.3558) in July 1996. This renovation involves the creation of a new black front like the renovated MP 59 and MF 67 of lines 3, 3 bis and 9. It also contains the replacement of the leather seats by anti-laceration seats and new interior colors with a dominant green and yellow shading. Fluorescent lighting was also improved. The renovation of the entire series began in September 1998 after tests with the 6529 which served as a prototype for renovation. It was undertaken jointly by the RATP workshops in Fontenay-sous-Bois and Boissy-Saint-Léger as well as the Cannes La Bocca Industries workshops. The first refurbished trainset was brought back online in April 1999. The refurbishment program ended in 2002. In 2012, all the MP 73 trainsets in service were refurbished.

In 2017 and 2018, the MP73 was renewed again. On this occasion, the doors received a light gray coating on their interior side, thus losing their chrome appearance.

The withdrawal of MP 73 began at the end of 2022, as they are being replaced by the MP 89 CC (currently used on line 4 and line 6 of the Paris metro).[6][7]

The only MP 73 on line 11 (6544) was removed in July 2022.

MP 73s are limited to 70 km/h (43 mph). Each power car is equipped with four 100 kW (130 hp) motors operating at 750 volts. They are controlled by a JH camshaft driven by a 72 V low voltage servo motor, with thirty notches. The low voltage of 72 V, also used for lighting, is supplied by a rotary converter. Braking has eleven notches on the manipulator, entirely pneumatic; it is controlled by a solenoid valve.[8]

They have ribbed tires, lighter bodies, new aesthetics of the front end and more comfortable seats. They are equipped with the same motors (Type MP4) as the MP 68 of the Mexico City metro.

Due to steep gradients on the line, and very close stations, the trainsets keep a high M/T ratio to be able to obtain enough power in the climbs and powerful accelerations.

Like all metros with tires in Paris (except the Mp14) the brake shoes are made of wood.

A set of 2 folding seats

Door Handle

The standard MP73 passenger car contains 24 folding seats facing the standing areas and 24 full seats, in 2x2 face-to-face configuration. Each car can seat a total of 48 people. In addition, each car has 8 handle poles for standing passengers and 12 seatback handles for people in the aisles. There are 16 door-side handles as well. The doors are opened manually using a lever handle (pictured) and are closed automatically by the conductor.

A set of 4 full seats in the standard configuration

MP73 wagons are named in the following way:

• The numbers M.3501 to 3602 are assigned to powered end wagons, of which 102 were made
• The numbers N.4501 to 4550 are assigned to powered passenger wagons with no driver cabin
• The numbers A.6501 to 6550 are assigned to unpowered wagons that used to be first class wagons
• The numbers B.7001 to 7050 are assigned to unpowered wagons that used to be second class wagons

It is the number of car named A which is used to designate the entire train (number present in two places on the two front faces of a train). The MP 73 trains are therefore numbered from 6501 to 6550, even if the numbers of the other cars do not always correspond. For example, a trainset of normal composition would include the following boxes: M.3501, N.4501, A.6501, B.7001 and M.3502. Even if the train had a mismatched composition, the number would remain 6501. This law is valid for all material before Mp89.

uses trains in a 5-car formation (3M2T).

45 five-car sets are allocated to Paris Italie Depot for use on Line 6, as shown below.

The MP 86 was a test MP 73 with engines and suspensions from the MPM 76 of the Marseille metro which ran on line 11 of the Paris metro until at least 1999 in M-T-T-M composition.

The RATP does not wish to communicate on this prototype, and little information is available. Nevertheless, according to testimonies from people working at the workshop located in Châtelet, the MP 86 was equipped with Renault VI heavy truck drive axles and Faiveley wipers. These bogies were of the ANF brand; the traction motors were of the Alsthom MP 41 A type.

The composition of the MP 86 is also known[9] and comes in the M-B-B-M form, i.e. two motor cars with cabin (M) and two type (B) trailers. One of the two trailers has automatic pilot equipment. The composition of the numbers was as follows, M n° 3599 & 3600, B n° 7006 & 7050. A photo of the MP 86 prototype can be seen in the book Le métro de Paris, by Gaston Jacobs (page 107), where the oar on the right of MP 55 #5513 is oar #7006, bearing the number of one of the trailers. It is no longer possible to find this train which has been deregistered. Only car B.7006 survives and circulates incorporated into train no. 6506.

• 
  Mp73 Bogie

Wikimedia Commons has media related to MP 73.

• TRUCK (bogie)