Dens evaginatus
Dens evaginatus is a rare odontogenic developmental anomaly that is found in teeth where the outer surface appears to form an extra bump or cusp.
Dens evaginatus | |
---|---|
Other names | Tuberculated cusp, accessory tubercle, occlusal tuberculated premolar, Leong's premolar, evaginatus odontoma, occlusal pearl[1][2] |
Specialty | Dentistry |
Premolars are more likely to be affected than any other tooth.[3] It could occur unilaterally or bilaterally. [1] Dens evaginatus (DE) typically occurs bilaterally and symmetrically.[4] This may be seen more frequently in Asians[3] (including Chinese, Malay, Thai, Japanese, Filipino and Indian populations).[4]
The prevalence of DE ranges from 0.06% to 7.7% depending on the race.[3] It is more common in men than in women,[3] more frequent in the mandibular teeth than the maxillary teeth.[1] Patients with Ellis-van Creveld syndrome, incontinentia pigmenti achromians, Mohr syndrome, Rubinstein-Taybi syndrome and Sturge Weber syndrome are at a higher risk of having DE.[3][2]
Signs and symptoms
It is important to diagnose DE early and provide appropriate treatment to help prevent periodontal disease, caries, pulpal complications[3] and malocclusion.[2] It occurs on the cingulum/occlusal surface of the teeth. The extra cusp can cause occlusal interference, displace of the affected tooth and/or opposing teeth, irritates the tongue when speaking and eating and decay the developmental grooves. [2] Temporomandibular joint pain could be experienced secondarily due to occlusal trauma caused by the tubercle.[1][2]
This cusp could be worn away or fractured easily.[1][4][2] In 70%[4] of the cases, the fine pulpal extension were exposed which can lead to infection,[4] pulpal necrosis and periapical pathosis.
Associated anomalies
- Additional tubercules[2]
- Aesthetic and/or occlusion problems[2]
- Agenesis[3]
- Bifid cingula[2]
- Exaggerated cusp of Carabelli[2]
- Gemination[3]
- Impaction[2]
- Labial drifting[2]
- Labial groove[2]
- Mesiodens[3]
- Megadont[2]
- Odontoma[2]
- Peg-shaped lateral incisor[2]
- Prominent marginal ridge[2]
- Shallow groove in the lateral incisor[2]
- Shovel-shaped incisor[2]
- Supernumerary[2]
Cause
The cause of DE is still unclear.[2] There is literature indicating that DE is an isolated anomaly. During the bell stage of tooth formation, DE may occur as a result of an unusual growth and folding of the inner enamel epithelium and ectomesenchymal cells of dental papilla into the stellate reticulum of the enamel organ.[5] [4]
Diagnosis
Diagnosis of DE can be difficult when there is no signs and symptoms of necrotic or infected pulp.[1] It is a challenging task to differentiate between a true periapical lesion and a normal periapical radiolucency of a dental follicle of an immature apex.[1]
- Pulp tests (test results of immature teeth can be misleading, as they are known to give unreliable results)[1]
- Check and see if there is an elevated, flat wear facet on the occlusal surface of the tooth[1]
- Test cavity which has an absence of pain sensation and has an empty pulp chamber/ canal.[1]
- Radiographs (usually periapical) - a V-shaped radiopaque structure could be seen superimposing on top of the affected crown.[2][3] It could detect DE before tooth eruption. However, DE presentation on the radiograph can be quite similar to a mesiodens or a compound odontoma.[2]
Classification
The anterior DE tubercles have an average width of 3.5mm and length of 6.0mm,[4] while posterior tubercles have an average 2.0mm in width and length of up to 3.5mm.[4] If the cusp of Carabelli is present, the tooth associated are often larger mesiodistally and it is not uncommon that a DE involved tooth has an abnormal root pattern.[4]
There are 4 different ways to classify/ categorize DE involved teeth.
- Schulge (1987) classification, teeth falls into 5 categories according to the location of the tubercles[4] [2]
- Tubercle on the inclined plane of the lingual cusp
- Cone-like enlargement of the buccal cusp
- Tubercle on the inclined plane of the buccal cusp
- Tubercle arising from the occlusal surface obliterating the central groove
- Lau's classification, divide teeth into groups according to their anatomical shape[4][2]
- Smooth
- Grooved
- Terraced
- Ridged
- Oehlers classification, teeth categorized depending on the pulp contents within the tubercle (histological appearance of the pulps were examined)[4][2]
- Wide pulp horns (34%)
- Narrow pulp horns (22%)
- Constricted pulp horns (14%)
- Isolated pulp horn remnants (20%)
- No pulp horn (10%)
- Hattab et al. classification[2]
- Anterior teeth
- Type 1 - Talon, a well defined additional cusp that projects palatally and extends at least half the distance from the cementoenamel junction (CEJ) to the incisal edge
- Type 2 - Semitalon, an additional cusp that extends less than half the distance from the CEJ to the incisal edge
- Type 3 - Trace talon, prominent cingula
- Posterior teeth
- Occlusal DE
- Buccal DE
- Palatal DE/ Lingual DE
- Anterior teeth
Management
If the tooth involved is asymptomatic or small, no treatment is needed [3] and a preventative approach should be taken.
Preventative measures[3] include:
- Oral hygiene instruction[3]
- Scaling and polishing[3]
- Application of topical fluoride on reduced cusp[3]
- Application of fissure sealant[6][3]
- Frequent dental check-up, pay extra attention to fissures[2]
- Perform direct or indirect pulp capping[1] in cases with pulpal extension,[2] to try increase the rate of reparative dentin formation (but may result in obliteration of the canal)
- Seal exposed dentin with microhybrid acid-etched flowable light-cured resin[7]
- Perform pulpotomy with MTA using a modified Cvek technique[4]
For teeth with normal pulp and mature apex, reduce the opposing occluding tooth.[4] Reinforce the tubercle by applying flowable composite.[4][2] Occlusion, restoration, pulp and periapex assessment should be done yearly.[4] When there is adequate pulp recession, tubercle can be removed and tooth can be restored.[4]
For teeth with normal pulp and immature apex, reduce the opposing occluding tooth.[4] Apply flowable composite to the tubercle.[4] Occlusion, restoration, pulp and periapex assessment should be done every 3–4 months until the apex matures.[4] When there are signs of adequate pulp recession, tubercle can be removed and tooth can be restored.[4]
For teeth with inflamed pulp and mature apex, conventional root canal treatment could be carried out and restored accordingly.[4]
For teeth with inflamed pulp and immature apex, shallow MTA pulpotomy could be performed and then restore with glass ionomer and composite.[4]
For teeth with necrotic pulp and mature apex, conventional root canal therapy could be done and restored.[4]
For teeth with necrotic pulp and immature apex, MTA root-end barrier could be carried out. Glass ionomer layer and composite could be used to restore the tooth.[4]
If there is occlusal interference, the opposing projection should be reduced.[3][2] Make sure that the tubercle does not contact other teeth in all excursive movement.[2] This is usually done over a few appointments, 6 to 8 weeks apart to allow the formation of reparative dentin to protect the pulp.[3] Fluoride varnish should be applied onto the ground surface.[7][6][3][4] Recall the patient for follow-up after 3, 6 and 12 months.[3]
In some cases, extraction could be considered (e.g. for orthodontic purposes, failed apexification)[2]
References
- Echeverri EA, Wang MM, Chavaria C, Taylor DL (July 1994). "Multiple dens evaginatus: diagnosis, management, and complications: case report". Pediatric Dentistry. 16 (4): 314–7. PMID 7937267.
- Hülsmann M (March 1997). "Dens invaginatus: aetiology, classification, prevalence, diagnosis, and treatment considerations". International Endodontic Journal. 30 (2): 79–90. doi:10.1111/j.1365-2591.1997.tb00679.x. PMID 10332241.
- Manuja N, Chaudhary S, Nagpal R, Rallan M (June 2013). "Bilateral dens evaginatus (talon cusp) in permanent maxillary lateral incisors: a rare developmental dental anomaly with great clinical significance". BMJ Case Reports. 2013: bcr2013009184. doi:10.1136/bcr-2013-009184. PMC 3702862. PMID 23813995.
- Levitan ME, Himel VT (January 2006). "Dens evaginatus: literature review, pathophysiology, and comprehensive treatment regimen". Journal of Endodontics. 32 (1): 1–9. doi:10.1016/j.joen.2005.10.009. PMID 16410059.
- Borie E, Eduardo; Oporto V, Gonzalo; Aracena R, Daniel (June 2010). "Dens evaginatus in Hemophilic Patient: A Case Report". International Journal of Morphology. 28 (2): 375–378. doi:10.4067/S0717-95022010000200006. ISSN 0717-9502.
- Bazan MT, Dawson LR (September 1983). "Protection of dens evaginatus with pit and fissure sealant". ASDC Journal of Dentistry for Children. 50 (5): 361–3. PMID 6580300.
- Koh ET, Ford TR, Kariyawasam SP, Chen NN, Torabinejad M (August 2001). "Prophylactic treatment of dens evaginatus using mineral trioxide aggregate". Journal of Endodontics. 27 (8): 540–2. doi:10.1097/00004770-200108000-00010. PMID 11501594.