How to Assemble a Plasmacar Toy

This article provides the reader with clear and concise steps to assembling PlaSmart's PlasmaCar.

Steps

  1. Image titled Assemble a Plasmacar Toy Step 1
    1
    Fill the notch on each rear wheel housing into the body. Push the wheels in at a 45 degree angle. When installed correctly, the rear wheels flare out from the body. Warning The rear wheel housing cannot be removed once locked into place.
  2. Image titled Assemble a Plasmacar Toy Step 2
    2
    Strike the rear wheels with a rubber mallet to secure them in place. Note: To use a steel hammer, place a small block of wood on the are to be struck.
    Advertisement
  3. Image titled Assemble a Plasmacar Toy Step 3
    3
    Remove the foam sheath from the front wheel assembly.
  4. Image titled Assemble a Plasmacar Toy Step 4
    4
    Guide the front wheel shaft through the body, into the foam sheath, and through the hole at the top of the body.
  5. Image titled Assemble a Plasmacar Toy Step 5
    5
    Strike the base of the front wheel assembly with a rubber mallet. The metal bearing should be seated securely in the body.
  6. Image titled Assemble a Plasmacar Toy Step 6
    6
    Fit the steering wheel into the top of the front wheel assembly. Note: Ensure that the bolt is attached to the steering wheel as shown.
  7. Image titled Assemble a Plasmacar Toy Step 7
    7
    Align the steering wheel with the smaller front wheels, so that the wide end of the steering wheel faces forward. Note: When the front wheels are assembled and resting on a flat surface, the smaller front wheels do not contact the ground.
  8. Image titled Assemble a Plasmacar Toy Step 8
    8
    This step is critical to operate your car use a 17 mm socket wrench to tighten the nut in the steering column AS TIGHT AS POSSIBLE. Fit the wrench onto the nut and turn until very tight. Alternatively, use the enclosed hex key and a screwdriver to tighten the nut AS TIGHT AS POSSIBLE.
  9. Image titled Assemble a Plasmacar Toy Step 9
    9
    Push the cap into the steering wheel.
    10. Advertisement

Warnings

Advertisement

You Might Also Like

How to
Assemble a Skateboard
Assemble a Tent
How to
Assemble a Tent
Kickflip on a Tech Deck
How to
Kickflip on a Tech Deck
How to
Make a Beyblade
Fingerboard
How to
Fingerboard
Make a Fingerboard Skatepark
How to
Make a Fingerboard Skatepark
Ollie on a Tech Deck Using Three Fingers
How to
Ollie on a Tech Deck Using Three Fingers
Make a Beyblade Stadium
How to
Make a Beyblade Stadium
Change the Batteries in a Buzz Lightyear Action Figure
How to
Change the Batteries in a Buzz Lightyear Action Figure
How to
Make a Ball
Make a Paper Fingerboard
How to
Make a Paper Fingerboard
How to
Make a Spinning Top
Completely Customize a Tech Deck
How to
Completely Customize a Tech Deck
How to
Make a Fidget Spinner
Advertisement

References

  1. PlaSmart's/Plasmart

About This Article

wikiHow is a “wiki,” similar to Wikipedia, which means that many of our articles are co-written by multiple authors. To create this article, volunteer authors worked to edit and improve it over time. This article has been viewed 58,932 times.
35 votes - 53%
Co-authors: 8
Updated: September 20, 2022
Views: 58,932
Categories: Action Toys
Advertisement