A beginner's guide to properly using your camera

The Praktica MTL3 is a tough, reliable, and enormously popular mechanical camera from the late 1970s that sells for almost nothing and is a great choice for the photography student who requires a fully-manual camera for their studies, or for the photographer who loves having indestructible German engineering in their hands.

Method 1
Method 1 of 5:

Preparation

  1. 1
    Fit a battery, if one is not already fitted. The cover for the battery is on the underside of the camera.
  2. 2
    Fit the lens.
  3. Advertisement
Method 2
Method 2 of 5:

Loading a film

  1. 1
    Lift the rewind knob. This is on the top of the camera, towards the left if the back of the camera is facing towards you.
  2. 2
    Pull it a little further and the back of the camera will spring open.
  3. 3
    Drop a 35mm film canister into the chamber on the left hand side. The flat end of the canister will be pointing upwards.
  4. 4
    Push the rewind knob all the way down. You may find you have to rotate it a little in one direction for the fork attached to it to fully enter the film canister. This is normal.
  5. 5
    Pull the film leader away from the canister till the tip is at the green index mark on the right hand side, next to the take-up spool. Ensure that the film properly engages the sprockets as marked in the picture.
  6. 6
    Close the back of the camera.
  7. 7
    Press the shutter button, then wind on your film. The shutter might not fire the first time if it's not armed already, of course, in which case just wind the camera on.
  8. 8
    Repeat the above step until the frame counter reads 1, as pictured. Don't fire the shutter once the frame counter reads 1; this is the first frame on your roll.
  9. 9
    Set the film speed on the film speed dial. The film speed dial is in the same place as the shutter speed dial; it's the silver dial around the outside, which can move independently.To change the film speed, pull the silver ring around the shutter speed dial upwards. While holding it there, rotate the dial until you have set your desired film speed.Notice that the MTL3 has both DIN and ASA settings; modern films typically give their ratings in ASA (which is called ISO on digital cameras). (For example, Fuji Velvia 50 is ASA 50, not 50 ° DIN, the latter being equivalent to an ASA speed in the high five figures.
  10. Advertisement
Method 3
Method 3 of 5:

Shooting

  1. 1
    Look through the viewfinder. You will notice the following things:
    1. A triangle on the left hand side. This only appears in our photo above, or in your viewfinder, if you have not armed the shutter.
    2. A needle on the right hand side. This is a meter reading. Take note of the +, O and - markings on the scale; we'll be referring to them later.
    3. Three circles in the centre of the image, which are your focusing aids.
  2. 2
    Focus. Turn the focus ring of your lens until you have a sharp picture. You have three focusing aids that will help you.
    • The split-image in the centre. This will cause straight vertical lines to appear split in half if they are out of focus, and they will rejoin when they are in focus. Sometimes half of this image will be blacked out, for example with slow lenses (f/4 and slower).
    • The microprism ring outside of that will shimmer when the subject in that area is out of focus, and will be clear when it is in focus.
    • The ground glass of the circle around that will help you if the above focusing aids are not helpful in your shooting situation.
  3. 3
    Set the exposure. The MTL3 is a fully manual camera, but this is hardly any harder than doing the same thing on a digital SLR in manual mode.
  4. 4
    Shoot! Press the shutter button all the way down; you'll get a nice, reassuring click from the shutter.
  5. 5
    Wind on your film to the next frame and keep shooting until you hit the end of your roll of film.
  6. Advertisement
Method 4
Method 4 of 5:

Unloading the film

  1. 1
    Press the rewind release button on the base of the camera.
  2. 2
    Flip out the rewind crank on the rewind knob.
  3. 3
    Rewind the film in the direction indicated on the rewind crank (looking from the top of the camera, you want to turn it clockwise). Keep winding until you feel the film disengage from the wind-on mechanism (it'll get much, much easier to turn), then turn it a couple more times.
  4. 4
    Open the back of the camera by lifting the rewind knob upwards, just as you did to load the film earlier.
  5. 5
    Remove the canister then close the back of the camera.
  6. 6
    Take your film to be developed and show off the results to the world!
  7. Advertisement
Method 5
Method 5 of 5:

Using the self-timer

It is generally not advisable to use the self-timer on an old mechanical camera like the Praktica MTL3. The mechanism, if it has not been used in a long time, can jam, requiring either a skilled camera technician or brute force (which often requires a more expensive trip to said camera technician) to un-jam it. However, if you really must:

  1. 1
    Make sure the shutter is armed by winding on the film.
  2. 2
    Locate the self-timer lever. This is to the left of the lens mount, if you are looking at the front of the camera. Not all MTL3s are fitted with self-timers, so if yours is not, rejoice: you just saved yourself a trip to a skilled camera technician.
  3. 3
    Pull the lever upwards (clockwise, looking from the front of the camera) to the top of its travel; it will lock in place.
  4. 4
    Press the silver button in the middle of the pivot of the self-timer lever. The timer will run for about 8 seconds and then the shutter will fire.
  5. Advertisement

Community Q&A

  • Question
    I cannot see anything through the view finder and for me it appears to be closed. What am I missing?
    Community Answer
    Community Answer
    You just need to take off the lens cap.
Advertisement

Things You'll Need

  • A Praktica MTL3, which you can buy for almost nothing.
  • A lens. Any screw-mount M42 lens will work fine, though the Pentacon 50mm f/1.8 that you can often get included with the body is a great all-round lens.
  • A standard canister of 35mm film. Any film you're likely to find today will work fine.
  • PX625 battery. The Praktica MTL3 is designed for widely-banned 1.35v mercury cells, but numerous reports suggest that it has a voltage regulation circuit in the camera, so the 1.5v alkaline cells will work just fine. If you're paranoid, you can get a WeinCell MRB625 cheaply enough (although they cost somewhat more than 1.5v alkalines), which has very similar electrical characteristics.

About This Article

wikiHow is a “wiki,” similar to Wikipedia, which means that many of our articles are co-written by multiple authors. To create this article, volunteer authors worked to edit and improve it over time. This article has been viewed 189,755 times.
64 votes - 99%
Co-authors: 8
Updated: May 25, 2022
Views: 189,755
Advertisement