A clew knot is a useful knot frequently used for hammock making. It is simple to do but can get a bit tricky depending on how many lengths you're handling at once, so a good numbering system can be helpful there. This article presents a clew knot using twelve half cords; you will need to adjust the measurements according to the number of cords your project requires you to work with.

Part 1
Part 1 of 12:

Getting started

  1. 1
    Fold six lengths of cord in half. Attach to a ring, rod, or other form of holder to keep in place.
    • Secure with a larks head knot.
  2. 2
    Number the cords in your head. Use numbers 1 to 12 and keep the numbering system steady in your mind as you work with the cords.
    • If you can't remember the cord numbers very well, use markers such as small plastic bread tabs with the numbers written on them - slip these over the cords, then shift and remove these as needed,
    Advertisement
  3. 3
    Pull the cords apart evenly. Pull them taut to straighten. As cords are done with, you'll be tucking them off to the side when they are no longer needed.
  4. 4
    Get ready to weave. Weaving goes left-to-right, then right-to-left and each set of left-to-right/right-to-left must alternate between under/over and over/under. The instructions will make this clear.
  5. Advertisement
Part 12
Part 12 of 12:

Finishing up

  1. 1
    Do not weave cords #6 and #7. Pull the ends of both cords #6 and #7 to tighten the clew knot.
  2. 2
    If attaching this knot as part of a hammock, the loose ends of the cords are attached in the opposite order to that in which they were woven.[3]
    • This means that cords #6 and #7 will be attached at the center of the hammock rod or ring.
    • Attach cords #8 and #5, then cords #9 and #4.
    • Attach cords #10 and #3, then cords #11 and #2.
    • This leaves cords #12 and #1 to be attached last.
  3. Advertisement

Community Q&A

  • Question
    How much rope is needed?
    T. Chinsen
    T. Chinsen
    Top Answerer
    Rope quantity varies with the tension of the weaving. More will be used if tension is loose, less if tight. Start with a 2-yard (2-meter) length of rope to get an approximate range of where you end up after weaving the clew knot. Always add more than you think you need, as nothing is worse than having to start over when there is not enough rope to make a knot. Depending on the rope thickness, about 5x the width of the rope is used up to make a single knot for tying off.
Advertisement

Things You'll Need

  • Rope
  • Scissors
  • Ring, rod, or other form of holder to keep rope in place.
  • Flat surface to work upon

About This Article

wikiHow is a “wiki,” similar to Wikipedia, which means that many of our articles are co-written by multiple authors. To create this article, 12 people, some anonymous, worked to edit and improve it over time. This article has been viewed 75,656 times.
150 votes - 87%
Co-authors: 12
Updated: May 20, 2021
Views: 75,656
Categories: Hammocks
Advertisement