How to Change a Washer on a Garden Tap

Last Updated: September 5, 2022 References

A leaky faucet (tap) in your home can cost you money in water bills; a leaky outdoor faucet can not only cost you money, it can cause damage to your garden and grass in addition to your home itself. Fortunately, leaky faucets of any kind are usually caused by a worn-out washer. Replacing a worn-out washer is a simple process that takes very little time and only a few common tools.

Steps

1
Locate the main water valve.^{[1]
X
Research source}
2
Turn off the water to your house.^{[2]
X
Research source}

Advertisement
3
Locate the nut that sits just behind the faucet knob.
4
Remove the nut using an adjustable wrench.^{[3]
X
Research source}
5
Pull the faucet handle straight out to remove the valve stem; it should be approximately 12 inches (30.5 cm) long.
6
Remove the screw at the end of the long valve stem using a flat-head screwdriver.^{[4]
X
Research source}
7
Pry the old washer out carefully using a small screwdriver.^{[5]
X
Research source}
8
Find a new washer of the same size and shape.
9
Clean the seat where the washer will go with a small soft brush or toothpick.
10
Insert the new washer, ensuring a snug fit.
11
Replace the screw on the end of the valve stem.^{[6]
X
Research source}
12
Grease the threads on the valve stem with some silicone to make the faucet turn on and off easier.^{[7]
X
Research source}
13
Replace the valve stem into the faucet pipe.
14
Wrap the faucet threads with plumber's tape to ensure a snug fit.
15
Reattach the faucet knob.
16
Tighten the packing nut.
17
Turn on the main water valve.
18
Turn on the outside spigot.
19
Let the water run for several minutes to clean out any debris that may have gotten inside the valve stem and spigot while working on them.^{[8]
X
Research source}
20
Shut off the spigot.
21
Inspect the spigot to ensure that there are no leaks.

Community Q&A

Question

How can I remove the faucet if it will not come out?

Community Answer

Cut the faucet off the pipe and install a new faucet. You can solder on a new faucet or thread fitting. Alternatively, you can screw on a compression fitted valve to a plain pipe.

Warnings

Use care and patience when reinstalling the valve stem. There are threads on both the valve stem and the inside pipe to which it attaches. These can be easily stripped or damaged if the parts are forced together in any way or are not seated correctly. You may need to adjust both the valve stem and packing nut at the same time to get the correct fit.

⧼thumbs_response⧽
Helpful 3 Not Helpful 3