How to Clean up Battery Acid Spills

Co-authored by Duston Maynes

Last Updated: January 5, 2023 References Approved

Liquid or residue from leaking batteries can cause serious harm, so approach the cleanup task with caution. Identifying the type of battery before clean-up is extremely important, or you could risk a dangerous chemical reaction. If the battery was powering a device while it was damaged, you may need to clean the electrical contacts as well, or have them replaced.

1

Protect your hands and face.

Battery leaks can contain caustic chemicals that irritate the skin, lungs, and eyes. Always wear rubber, nitrile, or latex gloves before you handle the leaking battery or the leaked material. Wearing safety goggles or a face mask is highly recommended when handling car batteries or lithium batteries. Work in an area with good ventilation, blowing away from your face.^{[1]
X
Research source}
- If you feel a burning sensation in your eyes or on your skin, or if the spill gets on you, leave the area and remove affected clothing. Rinse in lukewarm, gently flowing water for at least 30 minutes.^{[2]
  X
  Research source}
- Acid leaks, typically from a car battery, are much more dangerous than alkaline battery leaks.

2

Double-bag the battery

For small batteries, use transparent plastic so you can identify the type of battery before you continue. For car batteries and other large batteries, put them inside two trash bags, ideally made from 6mm+ (0.2 in) thick polyethylene. Tie or seal the bag closed immediately.^{[3]
X
Research source}

3

Determine the battery type

Batteries for cars and other motor vehicles are almost always lead-acid batteries.^{[4]
X
Research source} Smaller batteries that slot into electric devices are more varied, so examine the label to find the type. The most common types for small batteries are alkaline, lithium, and nickel cadmium, followed by lead-acid.
- Size and shape alone are not reliable identification methods.

4

Guess at battery type based on voltage

If the only label is the voltage display (V), you can make an educated guess: Alkaline batteries have voltages that are multiples of 1.5. Lithium battery voltages can vary, but are often written as multiples of 3 to 3.7. Nickel cadmium voltages are multiples of 1.2, and lead-acid batteries are multiples of 2.^{[5]
X
Research source}

5

Use baking soda to neutralize lead-acid or nickel cadmium spills

These types of battery can leak a strong acid, which eats through clothing, carpet, or in some cases even metal. Approach it with protective gloves and face shield, and cover liberally with baking soda, until newly added baking soda does not cause additional fizzing or bubbling. Clean up remaining residue using a thick paste made from baking soda and water.^{[6]
X
Research source}
- Also pour baking soda into the trash bag containing the damaged battery.

6

Clean up alkaline spills with mild household acid

For alkaline batteries, dip a cotton swab in vinegar or lemon juice, and swab the spill to neutralize the basic leak.^{[7]
X
Research source} Use an old toothbrush dipped in the same material to scrub at a spill that has dried. Water can cause further corrosion, so wet a paper towel as lightly as possible and use that to wipe up the acid.^{[8]
X
Trustworthy Source
United States Environmental Protection Agency
Independent U.S. government agency responsible for promoting safe environmental practices
Go to source} Repeat until clean, then let the device dry for several hours.

7

Wipe up lithium spills with water.

For lithium batteries, often used in cell phones or "button" batteries, immediately place the bag in a sealed, sturdy container, as it could cause a fire or explode. Any electric device exposed to the leak is no longer safe to use. Throw the device away, and clean up spills with water and nothing else.^{[9]
X
Research source}

8

Dispose of the batteries

In some states and countries, you may dispose of alkaline batteries in the regular trash, but most batteries are required by law to be recycled.^{[10]
X
Research source} Visit earth911's online tool to find a nearby hardware store or other location that will recycle your type of battery.
- Some battery manufacturers may offer you a free or reduced-price replacement battery.

9

Clean the electrical contacts (optional)

If the battery was connected to a device when it leaked, the device's electrical contacts may need to be cleaned before the device can be safely used. Scrape off any residue using a plastic or wooden stick, and use a slightly damp paper towel to wipe it off, throwing the towel away immediately. If the contacts themselves are corroded, pitted, or discolored, file them down using sandpaper or a metal file, but be aware that they may need replacement.^{[11]
X
Research source}

Community Q&A

Question

Is rubbing alcohol okay for alkaline battery spills? A tech friend once advised this.

Community Answer

It's better to use vinegar or lemon juice; you want a mild acid to neutralize the alkaline substance.
Question

I have an old battery box from an electric forklift that is very corroded from the old batteries. Can I clean this and use in an a pot for a flower garden or vegetables?

Community Answer

Is not a good idea, because the box can still contain some pollutant leaked by the battery. Any kind of vegetables you put in can absorb those pollutants.
Question

How do I clean acid battery from a golf cart?

Community Answer

You can either get some battery acid cleaner at an auto parts store or mix some baking soda and water to use to clean the acid. Wash away the residue with water.

Warnings

Large spills involving many liters (several gallons) of liquid or more should be handled by the fire department. Call an emergency number and keep everyone away from the area.

⧼thumbs_response⧽
Helpful 0 Not Helpful 0